Abstract:Displacement piles are driven to support a wide range of structures. However, analysis of the stress and strain fields developed during their installation remains one of the most challenging problems in geotechnical engineering. Advances in design methods, particularly for sand sites, have had to rely on an imperfect analogy between pile and cone penetration test (CPT), rather than modeling pile installation itself. Recent physical model experiments have provided benchmark data sets that describe the stress and deformation patterns developed around displacement piles penetrating sand masses. Following from large-deformation finite-element analyses that captured the stresses measured in the Grenoble 3S-R calibration chamber NE34 sand experiments, this paper presents simulations of the displacements measured in equivalent high-quality experiments conducted at Purdue University with dense, angular #2Q-ROK silica sand. A modified Mohr-Coulomb model with state-dependent parameters was calibrated to match element tests conducted by the authors, and an arbitrary Lagrangian-Eulerian scheme was applied in the simulations. The evolution and distribution of the deformations induced by pile penetration are compared with the experiments. Predictions for the deformation and strain fields applying during and after pile installation are presented, showing broad agreement between the simulations and experiments. The predicted and measured pile capacities are also compared and contrasted. Points of divergence between the simulations and tests are highlighted and their implications for numerical modeling are discussed.

Finite Element Analysis of Bearing Capacity and Deformation for Piles-Supported Embankments

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

ESTABLISHMENT OF THREE DIMENSIONAL COMPOSITE MODEL AND ITS APPLICATION TO COMPOSITE FOUNDATION WITH GRANULAR PILES

Finite Element Analysis of Deformation Characteristics of Composite Foundation with Rigid-Flexible Piles

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Simplified Analysis Method for Evaluating Horizontal Deformation of Single Pile Due to Adjacent Foundation Pit Excavation

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Analysis Of Deformation And Internal Force For Single Pile Under Combined Vertical And Lateral Loads Considering Yielding Of Soil

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

A Large Deformation Finite Element Investigation of Pile Group Installations with Consideration of Intervening Consolidation

Mesomechanical analysis of bearing characteristics of pile-supported embankment with particle flow code

Internal Force and Deformation Analysis of Pile-Brace Support Structure of Foundation Pit Considering Deformation Compatibility

Analysis of stress and failure mechanism on composite foundation improved by rigid piles under flexible foundation considering damage of piles

Elastic Solutions for Partially Embedded Single Piles Subjected to Simultaneous Axial and Lateral Loading

Stability of composite foundation improved by rigid piles under embankment considering different failure modes of piles

Analysis of Soil Movement Around a Loaded Pile Induced by Deep Excavation

Displacement and Force Analyses of Piles in the Pile-Caisson Composite Structure under Eccentric Inclined Loading Considering Different Stratum Features