Abstract:The critical micelle concentration (CMC) is an important parameter of widely used surfactants and needs to be measured in the application and development of surfactants. Fluorometric method is a widely used method determining CMC values owing to the advantages of highly sensitivity, fast response and wide application range. There are two common methods (I and II) of preparing samples for CMC fluorometric determination. In the process of developing CMC probes with aggregation-induced emission (AIE) characteristics, we found that methods I and II were not suitable for CMC probes with AIE charateristics and developed a new sample preparation method (III), which is not only suitable for CMC probes with AIE characteristic but also decreases operation procedures and errors owing to omitting the addition of micro amount of dyes into each sample. To ascertain if method III is also suitable for other CMC probes without AIE characteristics, the CMC values of surfactants were determined by fluorometric method using widely used pyrene without AIE charateristic as probe and methods I–III to prepare samples. The obtained experimental results proved that method III not only was suitable for preparation of samples for CMC determination of surfactants using pyrene as probe but also led to the least average deviation (methods I–III led to ±0.13, ±0.34 and ±0.05 mM deviation for the CMC determination of sodium dodecyl sulfate (SDS), respectively). The CMC determination using pyrene as probe is based on its change in the ratio ( I FIII / I FI ) of its emission peaks I and III with surfactant concentration. Unexpectedly, it was found that the I FIII / I FI value of pyrene in surfactant solutions is sensitive to the measurement conditions changing exciting light energy, such as slit widths and sample-measured number. In addition, it was found that surfactant SDS or cetrimonium bromide from different suppliers not only has significantly different CMC values but also leads to very different I FIII / I FI values of pyrene in a certain concentration of surfactant, which can be used as a simple method to distinguish the same surfactant with different CMC values.

Determination of the Critical Micelle Concentration for Tween 80/Solutol HS15 with the Steady-State Fluorescence Method

Determination of Critical Micellar Aggregation Numbers of Quaternary Ammonium Gemini Surfactants Containing Modified Rosin by Steady-State Fluorescence Probe Method

Fluorescence probe studies on the second critical micelle concentration of several kinds of surfactants

Influence factors on the critical micelle concentration determination using pyrene as a probe and a simple method of preparing samples

Detection of the critical micelle concentration of cationic and anionic surfactants based on aggregation-induced emission property of hexaphenylsilole derivatives

Determination of Critical Micelle Concentration (CMC) of Surfactants Using Environmentally Sensitive Carbonized Polymer Dots

Mechanistic Investigation of Drug Supersaturation in the Presence of Polysorbates as Solubilizing Additives by Solution Nuclear Magnetic Resonance Spectroscopy

Determination of surfactant critical micelle concentration by a novel fluorescence depolarization technique.

Interactions between Sodium Tetrafluoroethylene Pentamer-oxylbenzenesulfonate and Octyltriethylammonium Bromide

Determination of the Critical Micelle Concentration of Surfactant in Aqueous Solution by Twisted Intramolecular Charge Transfer Probe DMABN

Study on the Aggregation Behaviors of Composite Emulsifiers by Steady-state Fluorescence

On the determination of the critical micelle concentration by the pyrene 1:3 ratio method

[Studies on Micelle Behaviors of Sophorolipid Biosurfactant by Steady-State Fluorescence Probe Method].

Effects of Length and Type of the Alkyl Chain on the Micellization Behavior of Mixed Systems of HS15 with Fatty Acids.

ESTIMATION OF THE CRITICAL MICELLE CONCENTRATION OF NONIONIC SURFCTANTS BASED ON THE FLUORESCENCE MUTATION OF A NEAR-INFRARED HYDROPHOBIC CYANINE DYE

Fluorescence-probe study of anionic/cationic surfactant systems 2. Alkylsulfonate/alkyltrimethylammonium bromide

Study on Micelle Formation of Three Homologous Surfactants in Aqueous Solution by Surface Tension, Conductivity, and Fluorescence Measurements

Study of Micelle Formation by Fluorocarbon Surfactant N-(2-Hydroxypropyl)Perfluorooctane Amide in Aqueous Solution

Fluorescence Probe Studies of Bis(2-Ethylhexyl) Sodium Sulfosuccinate (aot) and Aot/Cetyltrimethylammonium Bromide (ctab) Systems

Photophysical Investigation of Methyl 2-Hydroxy-3-naphthoate (MHN23) in Different Self-Organized Supramolecular Assemblies of Micelles and Niosomes Formed by Nonionic Surfactant

Determination of the critical micelle concentration of sodium dodecyl sulphate in aqueous solution in the presence of an organic additive of acetonitrile by conductometry and an inorganic additive of phosphate by fluorometry