Abstract:Numerous molecular dynamics (MD) simulations have been performed to investigate the effect of the nanopores on the martensitic transformation (MT) of pure iron (Fe) during the heating-cooling cycle. As per the simulation results, nanopores can obviously affect the difficulty on MT during the cooling process in two ways: On the one hand, the volume ratio of nanopores to simulation box model (R p/b ) can influence the distribution configuration of stacking fault (SF) to change the type of austenite microstructure during the heating process owing to the obstruction of the nanopores on the dislocation slip. The effect of nanopores is not obvious when R p/b is less than 2.22 %. The main type of austenitic changes from defect-free/simple-SF types to the intersecting-SF type and, finally, to the dislocation-cell type with an increase in R p/b from 2.22 % to 17.9 %. The dislocations in intersecting-SF type and dislocation-cell type austenitic microstructures can provide the nucleation site of MT, thus increasing the MT temperature. On the other hand, the high surface energy of the nanopores caused by the incomplete atomic lattice can provide the necessary energy for the nucleation of martensite, which then promotes the occurrence of MT during the cooling process. When the nanopores intersect with the dislocation wall in dislocation-cell type austenitic microstructure, martensite nucleates at the nanopores surface and then grows along the dislocation wall. In the previous investigation of selective laser melting martensitic steel, the nanopore in the microstructure was generally believed harmful to the mechanical property of specimen; however, in this study, it has been observed to promote the MT during solution-quenching heat treatment, which improves the mechanical property by improving the content of martensitic phase. This provides a new perspective in determining the significance of nanopores in microstructures.

Effect of Lath Martensite Morphology on the Mechanical Properties of Steel

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

The morphology of lath martensite: a new perspective

A Hierarchical Theoretical Model for Mechanical Properties of Lath Martensitic Steels

New Insight into Toughness Enhancement in a Lath Martensitic Steel

Ausforming Effects on Anisotropy of Mechanical Properties in HSLA Martensitic Steel

Influence of austenite and martensite strength on martensite morphology

Effects of prior austenite refinement on microstructure and property of ultra-fine lath martensitic steel

Morphology of Retained Austenite and Its Effects on the Mechanical Properties of High Silicon Cast Steel

Effect of Prior Austenite Grain Size on the Morphology and Mechanical Properties of Martensite in Medium Carbon Steel

Influence of orientation-dependent lath martensite yielding on the hardening behavior of quenched martensitic steels

Influence of morphological parameter on the mechanical properties in a heterostructured medium Mn steel

Effects of martensite particle size and spatial distribution on work hardening behaviour of fine-grained dual-phase steel

Effect of hardness of martensite and ferrite on void formation in dual phase steel

Effect of martensite morphology and volume fraction on strain hardening and fracture behavior of martensite–ferrite dual phase steel

Effect of α‐Ferrite on Plasticity and Fracture Mechanisms of Dual‐Phase Ultrastrong Heterolamellar Steels

The effect of nanopores on the mechanism of martensitic transformation in pure iron during the heating-cooling cycle: A molecular dynamics study

Anisotropic slip behaviour of lath martensite block in ultra-low carbon steel

The effect of ferrite–martensite morphology on the scratch and abrasive wear behaviour of a dual phase construction steel

Formation of hierarchically structured martensites in pure iron with ultrahigh strength and stiffness

Effect of microstructure heterogeneity on the mechanical properties of friction stir welded reduced activation ferritic/martensitic steel