Abstract:This work aims to study the photo-response of the fabricated silicon-based Al/PVP:ZnTiO 3 /p-Si photodiode (PD) in a wide range of illumination intensities. To make a metal-polymer/nanocomposite-semiconductor (MPS) PD, a thin film of PVP:ZnTiO 3 nanocomposite is deposited at the interface of the metal-semiconductor (MS) structure. Information regarding the preparation and manufacturing procedures is provided. Through the examination of the current-voltage (I–V) behavior, essential electrical properties such as leakage current (I 0 ), barrier height (Φ B0 ), ideality factor (n), series and shunt resistances (R s , R sh ), energy-dependent interface states density (N ss ), photocurrent (I ph ), and photosensitivity (S) are acquired. The thermionic emission (TE) theory, along with the Norde and Cheung methods, is employed to calculate the parameters Φ B0 , n, and Rs. The values of Φ B0 and R s are decreased by raising the illumination intensity while the n value is increased. In addition, the illumination coefficient (α) and the value of Φ B0 in the ideal case are determined from the Φ B0 -P and Φ B0 -n plots. The efficiency (η) of the sample is calculated at each illumination intensity whose maximum value is 2.30 % at the intensity of 450 mW/cm 2 . The illumination-dependent photocurrent is investigated at the negative bias region that shows a good linear behavior in the ln(I ph )-ln(P) profile. The photosensitivity (S) of the fabricated PD is obtained as ⁓500 which is, compared with previous PDs. These findings demonstrate that the developed silicon-based MPS-type PD with a structure of Al/PVP:ZnTiO 3 /p-Si exhibits a good photo-response and can successfully replace traditional MS PDs in optoelectronic and photovoltaic applications.

Photoconduction and Photovoltaic Effects from A Conjugated Polymer Poly-Tert-Butyl-Isothionaphthalene

PCDTBT: from Polymer Photovoltaics to Light-Emitting Diodes by Side-Chain-Controlled Luminescence

Ultraviolet photoelectron spectroscopy of pristine poly (sodium poly[2-(3-thienyl)-ethoxy-4-butylsulfonate) (PTEBS) and doped with perylene tetracarboxylicdiimide (PTCDI) nanobelts

Photovoltaic Devices Based on a Novel Poly(phenylene Ethynylene) Derivative

Single-wall Carbon Nanotube/conjugated Polymer Photovoltaic Devices

Photovoltaic Properties of Dye Functionalized Single-Wall Carbon Nanotube/Conjugated Polymer Devices

Photovoltaic Response in Poly(3-Octylthiophene) Based Metal-Semiconductor-Metal Diodes.

Novel electron-acceptor conjugated polymer materials based on poly(thienylene ethynylene) derivatives

Novel Alternating Dioctyloxyphenylene Vinylene-Benzothiadiazole Copolymer: Synthesis and Photovoltaic Performance

Photoinduced intramolecular electron transfer in conjugated perylene bisimide-dithienothiophene systems: a comparative study of a small molecule and a polymer.

Carbon nanotubes as electron acceptors in polymeric photovoltaics

Photovoltaic cells based on dye-sensitisation of single-wall carbon nanotubes in a polymer matrix

Synthesis of a Conjugated Polymer with Broad Absorption and Its Application in High-Performance Phototransistors

Comparison of electrochemical and spectroscopic data of the low-bandgap polymer ptptb

Preparation and photovoltaic properties of the composite based on porous In2S3 films and PCPDTBT

A reduced electron-extraction barrier at an interface between a polymer poly(3-hexylthiophene) layer and an indium tin oxide layer

Organic Photovoltaics Incorporating Electron Conducting Exciton Blocking Layers

NIR polymers and phototransistors

Synthesis and Photovoltaic Effect of Electron-Withdrawing Units for Low Band Gap Conjugated Polymers Bearing Bi(thienylenevinylene) Side Chains

Optoelectric response of Schottky photodiode with a PVP: ZnTiO 3 nanocomposite as an interfacial layer

Solar Cells Constructed with Polythiophene Thin Films Grown along Tethered Thiophene-Dye Conjugates via Photoelectrochemical Polymerization