Optoelectric response of Schottky photodiode with a PVP: ZnTiO 3 nanocomposite as an interfacial layer

Ali Barkhordari,Hamid Reza Mashayekhi,Pari Amiri,Şemsettin Altındal,Yashar Azizian-Kalandaragh
DOI: https://doi.org/10.1016/j.optmat.2023.114787
IF: 3.754
2024-01-04
Optical Materials
Abstract:This work aims to study the photo-response of the fabricated silicon-based Al/PVP:ZnTiO 3 /p-Si photodiode (PD) in a wide range of illumination intensities. To make a metal-polymer/nanocomposite-semiconductor (MPS) PD, a thin film of PVP:ZnTiO 3 nanocomposite is deposited at the interface of the metal-semiconductor (MS) structure. Information regarding the preparation and manufacturing procedures is provided. Through the examination of the current-voltage (I–V) behavior, essential electrical properties such as leakage current (I 0 ), barrier height (Φ B0 ), ideality factor (n), series and shunt resistances (R s , R sh ), energy-dependent interface states density (N ss ), photocurrent (I ph ), and photosensitivity (S) are acquired. The thermionic emission (TE) theory, along with the Norde and Cheung methods, is employed to calculate the parameters Φ B0 , n, and Rs. The values of Φ B0 and R s are decreased by raising the illumination intensity while the n value is increased. In addition, the illumination coefficient (α) and the value of Φ B0 in the ideal case are determined from the Φ B0 -P and Φ B0 -n plots. The efficiency (η) of the sample is calculated at each illumination intensity whose maximum value is 2.30 % at the intensity of 450 mW/cm 2 . The illumination-dependent photocurrent is investigated at the negative bias region that shows a good linear behavior in the ln(I ph )-ln(P) profile. The photosensitivity (S) of the fabricated PD is obtained as ⁓500 which is, compared with previous PDs. These findings demonstrate that the developed silicon-based MPS-type PD with a structure of Al/PVP:ZnTiO 3 /p-Si exhibits a good photo-response and can successfully replace traditional MS PDs in optoelectronic and photovoltaic applications.
materials science, multidisciplinary,optics
What problem does this paper attempt to address?