Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Thermal optimization on micromachined convective accelerometer

An optimized micromachined convective accelerometer with no proof mass

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Determination of Thermally Induced Effects and Design Guidelines of Optomechanical Accelerometers

A Low-Power and Robust Micromachined Thermal Convective Accelerometer

The Analysis of Temperature Effect and Temperature Compensation of Moems Accelerometer Based on A Grating Interferometric Cavity

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

Thermal Stress Analysis of MEMS Accelerometer Based on Finite Element Method

Temperature Compensation Method for MEMS Accelerometer Based on Resonant Frequency

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

Sensitivity and Frequency-Response Improvement of a Thermal Convection-Based Accelerometer

Fabrication and Characterization of a MEMS Thermal Convective Accelerometer on Silicon-in-Glass Substrate

A Temperature-Insensitive Micromachined Resonant Accelerometer with Thermal Stress Isolation

Thermal Calibration of Triaxial Accelerometer for Tilt Measurement

A Review of Micromachined Thermal Accelerometers

In-Situ Compensation on Temperature Coefficient of the Scale Factor for a Single-Axis Nano-g Force-Balance MEMS Accelerometer

The design of AlGaN/GaN HEFT-micro-accelerometer and temperature-dependence electrical performance

Temperature-Insensitive Structure Design of Micromachined Resonant Accelerometers

Simulation-Based Design and Optimization of Accelerometers Subject to High-Temperature and High-Impact Loads

Temperature-drift Characterization of a Micromachined Resonant Accelerometer with a Low-Noise Frequency Readout