Abstract:Solid-oxide fuel cells (SOFCs) technology has a substantial potential in the application of clean and efficient electric power generation. However, the widespread utilization of SOFCs has not been realized because the cost associated with cell fabrication, materials and maintenance is still too high. To increase its competitiveness, lowering the operation temperature to the intermediate range of around 500–800°C is one of the main goals in current SOFCs research. A major challenge is the development of cell materials with acceptably low ohmic and polarization losses to maintain sufficiently high electrochemical activity at reduced temperatures. During the past few decades, tremendous progress has been made in the development of cell materials and stack design, which have been recently reviewed. SOFCs are fabricated from ceramic or cermet powders. The performances of SOFCs are also closely related to the ways in which the cell materials are processed. Therefore, the optimization of synthetic processes for such materials is of great importance. The conventional solid-phase reaction method of synthesizing SOFCs materials requires high calcination and sintering temperatures, which worsen their microstructure, consequently, their electrochemical properties. Various wet chemical routes have recently been developed to synthesize submicro- to nano-sized oxide powders. This paper provides a comprehensive review on the advanced synthesis of materials for intermediate-temperature SOFCs and their impact on fuel cell performance. Combustion, co-precipitation, hydrothermal, sol–gel and polymeric-complexing processes are thoroughly reviewed. In addition, the parameters relevant to each synthesis process are compared and discussed. The effect of different processes on the electrochemical performance of the materials is evaluated and optimization of the synthesis processes is discussed and some emerging synthetic techniques are also briefly presented.

Research of processing techniques used in fabrication of solid oxide fuel cells and study of their selected properties

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

The Recent Progress of Planar Solid Oxide Fuel Cell Stack

Fabrication and Properties of Anode-Supported Solid Oxide Fuel Cell

Recent progresses in the development of tubular segmented-in-series solid oxide fuel cells: Experimental and numerical study

High Performance Solid Oxide Fuel Cells Based on Tri-Layer Yttria-Stabilized Zirconia by Low Temperature Sintering Process

Advanced synthesis of materials for intermediate-temperature solid oxide fuel cells

The Progress on Research and Development of Tubular Solid Oxide Fuel Cell Stacks

Experimental investigation of temperature distribution in solid oxide fuel cells

Recent Novel Fabrication Techniques for Proton-Conducting Solid Oxide Fuel Cells

Development of metal-supported SOFC

Fabrication and Characterization of Composite Electrolyte for Intermediate-Temperature SOFC

Simple Solid Oxide Fuel Cells

Design and Fabrication of an Easily Assembled Anode Supported Microtubular SOFC Stack

Facile preparation of electrodes of efficient electrolyte-supported solid oxide fuel cells using a direct assembly approach

Rational SOFC material design: new advances and tools

Recent Progress on Advanced Materials for Solid‐Oxide Fuel Cells Operating below 500 °C

Failure Mechanism and Optimization of Metal-Supported Solid Oxide Fuel Cells

A High-Strength Solid Oxide Fuel Cell Supported by an Ordered Porous Cathode Membrane

The physical properties and effects of sintering conditions on rSOFC fuel electrodes evaluated by molecular dynamics simulation