Abstract:The main objective of the present article is to obtain the optimum technological parameters of the automobile plastic front-end frame. Moldflow software was used to simulate the injection molding of the automobile plastic front-end frame bracket in this study. The uniformity experiment was designed and completed. Five injection molding process parameters, including mold temperature, melt temperature, packing pressure, injection time, and packing time, were selected as experimental factors. Volume shrinkage and warpage amount were selected as quality evaluation indexes. Statistical Product Service Solutions (SPSS) software was used to perform linear regression analysis on the test results, respectively, and the linear regression equation corresponding to the two evaluation indexes was obtained. Then, regression equation analysis was carried out to obtain the optimal process parameter combination of the volume shrinkage and the warpage amount. A back propagation (BP) neural network model with input as a process parameter and output as an evaluation index is established by MATLAB and optimized by a genetic algorithm (GA). Finally, the optimized neural network model was used to predict the combination of process parameters with the minimum volume shrinkage and warpage amount. Based on the performed simulations, the minimum volume shrinkage and the minimum amount of warping in the optimal design were 13% and 0.7062 mm, respectively. The corresponding combination of process parameters was the mold temperature of 75.5°C, the melt temperature of 285.32°C, the packing pressure of 42.32 MPa, the injection time of 3.45 s, and the packing time of 60 s. According to the optimal process parameters, the volume shrinkage and warpage amount of the automobile plastic front-end frame have reached the optimal state at the same time, which improves the quality of injection molding and reduces production and processing costs. It has a certain guiding significance.

Moldflow-based optimization design of injection mould gate for box-shaped part

Single Gate Optimization for Plastic Injection Mold

Mould Design Optimization of Typical Part Based on CAE Analysis

Application of CAE for mold flow analysis in plastic molding mold design

Gate Location Design of Injection Molding Based on Feature Warpage Optimization

The Research on Gate Location Optimization of Injection Molding Based on Warpage

MoldFlow Analysis and Optimization of Injection Molding for of a Refrigerator Drawer

Optimization of Injection Mold Based on Fuzzy Moldability Evaluation

Application of Moldflow to Desigh Optimization of Injection Mold Gates

Research on Intelligent Control of Thin-Walled Plastic Parts Forming Quality Based on CAE and DOE Technology

Application of CAE Technology in Optimum Design of Injection Mold Gates

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

Mold design and forming process parameters optimization for passenger vehicle front wing plate

Surrogate Model and Improved Genetic Algorithm-Based Warpage Optimization of Injection Molding

Influence of mold design and injection parameters on warpage deformation of thin-walled plastic parts

Numerical Simulation and Mold Compensation of Warpage for Thin-wall Plastic Parts

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Research on the Application of Injection Molding Simulation Technology in Mold Design

Warpage analysis and optimization for auto interior ornaments based on CAE

Gate Location Optimization in Injection Molding Based on Empirical Search Method

Optimize the Warpage of Injection Molding of Cover Based on Orthogonal Test