Abstract:Goaf sealing wall is set in the roadway close to the stop line of working face in an underground coal mine. However, the sealing wall is prone to crack or fracture under serious mining stress, resulting in water and air leakage from goaf. In this study, the combination of polymethylene polyphenyl polyisocyanate (PAPI) and methylene diphenyl diisocyanate (MDI) as component A and polyether polyols, catalysts, surfactants, chain extenders, and plasticizers as component B were investigated to optimize the exothermic, foaming, and mechanical properties of modified polyurethane (PU) as the filling material for goaf sealing wall. Firstly, the reaction temperature of specimens with different contents of polyether polyols was monitored using a dynamic acquisition system; secondly, the effect of polyether polyols, catalysts, and surfactants on foaming property was studied; then, uniaxial compression tests were developed to obtain compressive behavior; finally, the microstructure after uniaxial compression was observed by using a scanning electron microscope (SEM). The results indicate that the pure chemical slurry is superior to the combination of chemical slurry and sand in compressive strength and deformation behavior. The optimal mass ratio of polyether triols, polyether tetraols, catalysts, surfactants, chain extenders, and plasticizers is 11 : 9 : 1.0 : 0.5 : 1.2: 6 in component B due to the maximum reaction temperature of 121.4°C, the expansion ratio of 2.6, and the compressive strength of 7.97 MPa at the strain of 10% in this study. The research provides a solution for the construction of the sealing wall, which is of great significance to safety production in an underground coal mine.

Research on Filling Technology of Expansion Sealant for Side Wall Cavity on a Vehicle

Numerical Analysis and Improving Design of Car Door Weatherstrip Seal

The Application of CAE Technique in the Design of Automotive Weatherstrip Seals

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Research progress in functional silicone sealant

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

State-of-the-Art and Future Development of Sealing Technology

Durability Analysis and Optimization Design of Filler Cap

Liquid-filling Auxiliary Device for Liquid-Filled Rock Joints and Its Application

Filling wall mechanical analysis of gob-side entry retaining with composite roof

Optimization of Exothermic, Foaming, and Mechanical Properties of Modified Polyurethane as Filling Material for Goaf Sealing Wall

Analysis and structure optimization on buckling destabilization and wrinkling of an automobile weather-strip seal in assemblage

Development and performance test of an expansive particle temporary plugging agent

Response Surface Method for Strength Analysis and Proportion Optimization of New Type Sealing Materials

Effect of filler on the compression set, compression stress-strain behavior, and mechanical properties of polysulfide sealants

Research Progress in Sealants for Solid Oxide Fuel Cell

Research Status and Development Trend of Cylindrical Gas Film Seals for Aeroengines

Effect of polyvinyl alcohol/aluminum microcapsule expansion agent on porosity and strength of cement-based drilling sealing material

A Model to Characterize the Lateral Expansion of a Cylinder Containing a Polymer Filler Subjected to Compression

Sealing Failure Analysis on V-Shaped Sealing Rings of an Inserted Sealing Tool Used for Multistage Fracturing Processes

Structural Design and Sealing Performance Analysis of a Nanofluidic Self-Heating Unsealing Rubber Cylinder