Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Analysis and structure optimization on buckling destabilization and wrinkling of an automobile weather-strip seal in assemblage

The Application of CAE Technique in the Design of Automotive Weatherstrip Seals

Numerical Analysis and Improving Design of Car Door Weatherstrip Seal

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Effectiveness analysis of the study on the bonding performance of car soft decoration coated interior trim based on cohesive zone model

Design and optimization of composite sub-stiffened panels

A Tolerance Analysis Method Based on Assembly Deformation Simulation with Stable Contact

Finite Deformation Mechanics In Buckled Thin Films On Compliant Supports

An enhanced higher-order finite element formulation for wrinkling analysis of thick sandwich plates

Optimization of thin-walled sealing structure based on mechanical simulation

Macro- and Mesoscopic Design for Cabin Door Pretightened Fabric Rubber Seal Structure

Comprehensive Performance Optimal Design of Metallic W-ring under Working Conditions

Finite element simulation investigation of warping deformation during baking temperature cycle of dissimilar materials sandwich adhesive bonded structures of car body

Structure Design on Thermoplastic Composites Considering Forming Effects

Design of Flexible Membrane Fixture for Automobile Door-Trim Infra Stake Welding Machine

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Optimal Crashworthiness Design of a Spot-Welded Thin-Walled Hat Section

Experimental and numerical studies on bending characteristics of woven CFRP reinforced aluminum thin-walled automotive structures

Optimization of the Laminate Structure of a Composite Cylinder Based on the Combination of Response Surface Methodology (RSM) and Finite Element Analysis (FEA)

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Multi-objective optimization of vehicle body B-pillar lower joints based on crashworthiness analysis