Abstract:Local area networks (LANs) are becoming popular in industrial computercontrolled systems increasingly. Broadcast LANs aimed at the interconnection of sensors, actuators and controllers are commonly known as fieldbus networks. Recently, the vendor-specific fieldbus has being substituted by vendor-independent standardized fieldbus, which supports the open system concept and has started to be used commonly. Particular relevance must be given to the IEC 61158 (1999), which encompasses eight widely used fieldbuses: FF HI, ControlNet, PROFIBUS, P-NET, FF HSE, SwiftNet, WorldFIP and Interbu (Xiuju 2000; Xiong 2000) known that time constraints are more stringent as we go down in the automation hierarchy. In this charter, we consider time constraints or deadlines as the maximum allowable time span between a message transfer request and its transmission on the bus. In fact, the total message cycle delay results from multiple factors, such as the access and queuing delays, the transmission time (frame length / transmission rate) and the protocol processing time. As we are dealing with realtime communication across a shared transmission medium, we focus our analysis on the access delay and queuing delay factors. These factors depend on the MAC (Medium Access Control) mechanism used by the fieldbus network. Fieldbus, as infrastructure of communication to support real-time traffic among field devices in factory floor, is one of typical real-time network. According to real-time application, protocol of MAC layer of fieldbus can be divided into event-triggered and time-triggered. The former does not support the real-time application directly and usually uses CSMA (Carrier Sense Multiple Access), like CAN and LON. The latter supports the real-time application directly and often uses token. Further, the time-triggered can be sub-divided into three classes: 1) centralized token in WorldFIP and Foundation Fieldbus; 2) distributed token in PROFIBUS and FDDI; 3) virtual token in P-Net. Recently, several studies on the ability of fieldbus networks to cope with realtime requirements have been presented, such as those by Tindell and Zuberi on

A Compatibleness Technology of Fieldbuses Based on Protocols Chip

A Design of Powered Device Interface Chip under PoE System

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Design and implementation of controller for a sensor network protocol

Applied Fieldbus into Communication Systems in ITS

Realtime Characteristic of FF Like Centralized Control Fieldbus and Its State-of-art

The IRCBus Communication Protocol Construction Design and Realization for Distributed Control System

Design of a High Speed Field Bus Control System Based on the ARM Processor

Application of Local- Bus Protocal for Field Bus

The New Dust Removal Controller Based on 80C196 Monochip with PSD Chip

Research on Filedbus Embedded Hardware and Its Technology

Application of C8051F020 and SPC3 in Distributed Control System Based on Field Bus

Design of a Generic Architecture for Smart Transducers

Real-time Communication Using Foundation Fieldbus

Brief Introduction to DCS and the Fieldbus Technology

Modbus experiment system based on C8051F02x singlechip

Research of SoC on Chip Bus

Dual- Channel High- Speed Data Transmission System of Industrial CT

A kind of according to CPLD of a machine and PCI connect a people's design solution

Design and Implementation of Mini-computer Control System

Application-oriented Wireless Sensor Network Communication Protocols and Hardware Platforms: A Survey