Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

Research on Joints Properties for Tunnel Convergence Deformation of Operating Metro

Analysis on the longitudinal deformation of tunnels due to pit excavation considering the tunnel shearing effect

Measurement on Soil Deformation and Numerical Simulation During Tunneling Process

Research on Convergence Deformation of Shield Tunnel with Elastic Limit Theory

Numerical Analysis Of Reasonable Spacing Between Tunnel Faces During Closely-Spaced Stacked Tunneling

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Deformation Behaviors of Joint between Shield Tunnel and Underground Station Impacted by Connected Deep Foundation Pit

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Investigation on deformation behavior and bearing capacity of a segmental ring based on the horizontal convergence

Analysis of longitudinal deformation for shield tunnel based on segment dislocation mode

Structure Analysis for Tunnel Longitudinal Deformation Based on Segment Dislocation Mode

Monitoring and Analysis of the Impact of Adjacent Bridge Pile Construction on Subway Tunnels

Influence of Pile Foundation Construction on Existing Tunnels in a Metro Protection Area: Field Test and Numerical Simulation

Full-scale Experimental and Structural Characterization Study of Shield Tunnel Reinforcement under Ground Stacking Loads

Full-scale Loading Test for Shield Tunnel Segments: Load-bearing Performance and Failure Patterns of Lining Structures

Numerical Simulation Study Considering Discontinuous Longitudinal Joints in Soft Soil under Symmetric Loading

Monitoring data analysis on the influence of large deep foundation pit excavation on nearby metro shield tunnel

Computational Analysis on Longitudinal Equivalent Bending Stiffness under the Influence of Shield-tunnel Transverse Deformation

Failure Mechanism of Tunnel Lining Joints and Bolts with Uneven Longitudinal Ground Settlement

Numerical simulation and simplified analytical model for the longitudinal joint bending stiffness of a tunnel considering axial force

Shear deformation characteristics and failure mechanisms of tunnel segment inter-ring joints: Numerical and experimental study