Abstract:Nowadays, ventilation ducts, especially duct bends, play a significant role in filtering aerosol contaminant for the built environment. This article experimentally investigates practical averaged aerosol deposition in 90° ventilated bends of rectangular cross section by measuring particle concentration changes at bend inlet and outlet in steady state. The measured penetrations at Reynolds number Re = 17,900 and 35,600 are in good agreement with previously published data at small Stokes number, which justifies the effectiveness of the measurement process. Particle penetration decreases from approximately 100% for St = 5.2 × 10−4 particles to 64% for St = 0.55 particles in acrylic glass bends. For the particles of Stokes number larger than 0.089, particle penetration is much higher than that in previous studies. This behavior is believed to be caused by the consideration of particle rebounce from bend wall in the presence of centrifugal force. The changes in Reynolds number do not significantly alter the trend of deposition velocity and penetration. Deposition velocities are compared and verified with available droplet data and current numerical and analytical analysis. For the high deposition velocity increase compared to that in straight ducts, the major mechanism is attributed to the flow impaction onto outer bend wall. In this type of bend, secondary flows and streamwise eddies provide a further reason for distinct deposition increase of small particles. In a word, the deposition mechanisms are analyzed analytically and systematically, and then classified in order clearly. In addition, two empirical models were proposed in this article, which are valid for Stokes number St = 5.2 × 10−4–0.55 under the experimental conditions. Copyright 2013 American Association for Aerosol Research

Numerical Investigation on Gas Flow and Pressure Drop for 90° Rectangular Ventilation Bends in Low Reynolds Number

Experimental Study on Forced Convection Hydraulic and Thermal Characteristics in a Dimpled Flat Duct

Numerical Simulation of Gas-Liquid Flow Through a 90° Duct Bend with a Gradual Contraction Pipe

Three-dimensional Numerical Simulation on Flow Past Three Circular Cylinders in an Equilateral-Triangular Arrangement

An experimental study of pressure drop and friction factor for laminar and transition opposing mixed convection in entrance region of rectangular duct

Experimental and Numerical Investigation on the Cavity Regime and Drag Reduction of Ventilated Partial Cavity

Study on resistance reduction in a jugular profiled bend based on entropy increase analysis and the field synergy principle

Experimental Study of the Flow Rectification Performance of Conical Diffuser Valves

Experimental Investigation of the Dynamic Cavitation Behavior and Wall Static Pressure Characteristics Through Convergence-Divergence Venturis with Various Divergence Angles

Experimental Study of Solid Particle Deposition in 90° Ventilated Bends of Rectangular Cross Section with Turbulent Flow

Numerical study of deposition rates of monodisperse particles in curved pipes with different expansion or shrinkage variables

Numerical Simulation and Flow Pattern Evolution of Gas-Liquid Two-Phase Flow Passing Through a 90° Pipe Bend Based on CFD

Pressure drop of turbulent flow across pipe bends

Numerical Investigation of the Thermohydraulic Performance of Double-Wave Cross-Corrugated Passages

Numerical Investigation and Optimization of the Flow Characteristics of Bend Pipe with Different Bending Angles

A computational study of curvature effect on pressure drop of gas-liquid two-phase flow through 90 degree elbow

Effect of Inflow Angle on High Reynolds Number Flows in Circular-Sectioned 90° Bends

Aerosol deposition in 90-degree bends: An enhanced empirical equation and a design concept of reducing losses

Numerical study on flow and heat transfer characteristics of low pressure gas in slip flow regime

Numerical Investigation of Tube-Side Fully Developed Turbulent Flow and Heat Transfer in Outward Corrugated Tubes

Experimental Investigation of Two Ventilated Cavities with Effect of Froude Number and Gas Entrainment