Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

Pressure drop of turbulent flow across pipe bends

Pressure-balanced Saint–Venant Equations for Improved Asymptotic Modelling of Pipe Flow

CFD-DEM Analysis of Hydraulic Conveying Bends: Interaction Between Pipe Orientation and Flow Regime

A computational study of curvature effect on pressure drop of gas-liquid two-phase flow through 90 degree elbow

Numerical Simulation of Laminar Flow in Various Curved Pipes Using a Boundary-Fitted Coordinate System.

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number

Effect of visco-plastic and shear-thickening/thinning characteristics on non-Newtonian flow through a pipe bend

Numerical Simulation of Gas-Liquid Flow Through a 90° Duct Bend with a Gradual Contraction Pipe

EFFECT OF INNER SURFACE ROUGHNESS ON PRESSURE DROP IN A SMALL DIAMETER PIPE

Numerical simulation for various curved pipes using a boundary-fitted coordinate system.

Numerical Investigation and Optimization of the Flow Characteristics of Bend Pipe with Different Bending Angles

Viscoelastic flow in rotating curved pipes

Prediction of Forced Gas Flows in Circular Tubes at High Heat Fluxes Accompanied by Laminarization

High Reynolds Number Computation for Turbulent Heat Transfer in a Pipe Flow

Optimizing pressure drop in 90° bend horizontal pipelines for dense slurry flow: A response surface methodology approach

Failure pressure prediction of high-strength steel pipe bend considering pipe and corrosion geometry

A numerical investigation on single-phase flow characteristics and frictional pressure drop in helical pipes

Modeling of liquid-solid flow erosion in curved pipes of gradually varying cross section

Numerical simulation of turbulent flow characteristic in a curved pipe with a baffle

Mechanical Behavior of Steel Pipe Bends: An Overview

Development of new improved plastic collapse moment equations of pressurized different angled pipe bends under bending moments