Abstract:Although inlet bent pipes are usually adopted due to limited installation space, the influences of different bend pipes on the inlet flow characteristics and performance of centrifugal compressors are still unclear. The numerical simulation of a centrifugal compressor is established and validated by experimental results with the case of a straight inlet pipe. Then, the internal flow characteristics of the centrifugal compressor with a 90-degree bent pipe (p90) and Z-shaped bent pipe (pz) are simulated and discussed. The results show that the adoption of two inlet bent pipes reduces the performance of the centrifugal compressor to a certain extent, which reduces more greatly with pz, with a maximum reduction of 6.82% in pressure ratio and 14.83% in efficiency, respectively. The pressure ratio and efficiency reduction of the centrifugal compressor both increase with the increment of distortion degree, which maintains the increasing trend as the flow rate increases, and the maximum distortion degree of p90 and pz reaches 0.0351 and 0.0479, respectively. The reduction degree of the pressure ratio shows a power–law relationship with the distortion degree, while the reduction degree of efficiency shows an exponential relationship with it. The flow characteristics at the outlet section of the inlet pipe affect the flow field distribution at the inlet of the impeller, and the distortion area ranges of the total pressure and axial velocity at the inlet of the impeller are near 72°–144° in the circumferential direction for p90, while those of pz are close to 108°–180° and 288°–360°. When the flow with a high distortion degree enters the impeller, a large area with high turbulent kinetic energy is formed in the downstream flow channel, resulting in an increase in the flow loss.

Effect of Inflow Angle on High Reynolds Number Flows in Circular-Sectioned 90° Bends

Numerical Investigation and Optimization of the Flow Characteristics of Bend Pipe with Different Bending Angles

Effect of Deflectors on the Flow Characteristics of a Square Pipe with a 90° Bend

CFD-DEM Analysis of Hydraulic Conveying Bends: Interaction Between Pipe Orientation and Flow Regime

Pressure-balanced Saint–Venant Equations for Improved Asymptotic Modelling of Pipe Flow

Numerical Simulation of Laminar Flow in Various Curved Pipes Using a Boundary-Fitted Coordinate System.

Numerical Simulation of Gas-Liquid Flow Through a 90° Duct Bend with a Gradual Contraction Pipe

Numerical Simulation and Flow Pattern Evolution of Gas-Liquid Two-Phase Flow Passing Through a 90° Pipe Bend Based on CFD

Numerical simulation for various curved pipes using a boundary-fitted coordinate system.

Viscoelastic flow in rotating curved pipes

Numerical Simulation of Flow Characteristic in Three-Dimensional Bend Pipes

Numerical Analysis on Unsteady Intermittent Flow in a Rotating Curved Pipe

Unsteady intermittent flow in a rotating curved pipe

Effect of visco-plastic and shear-thickening/thinning characteristics on non-Newtonian flow through a pipe bend

Numerical simulation and experimental verification of the velocity field in asymmetric circular bends

NUMERICAL ANALYSIS OF THE FLUID FLOW IN A ROTATING CURVED ELLIPTICAL PIPE

Effects of Inflection Curvature on Flow Interference at Furcating Fracture Intersections

Numerical Simulation on the Influence of Inlet Flow Characteristics on the Performance of a Centrifugal Compressor

Study on the aerodynamic performance of inlet pipe different bending radius of ram air system

PREDICTION OF FLOW FIELDS AT TRANSITION AREA BETWEEN TWIST PIPES

Effect of Small Inclination Angle on Heat Transfer Performance of Ca-Grooved Bending Heat Pipe