Abstract:Currently, with the increasing trend towards miniaturization and thinning of semiconductor devices, ensuring product reliability has become a crucial aspect in electronic packaging. This paper specifically focuses on MEMS temperature and humidity sensors and utilizes Moldex3D software for three-dimensional mold flow simulation analysis. The purpose of the analysis is to predict the distribution of potential air traps and identify the locations of weld lines. The influence of gate location and gate quantity on process defects and reliability issues is investigated using a single-factor method. The results clearly indicate that the design of the gate system has a significant impact on the reliability of sensor packaging. The simulation results for different gate locations demonstrate that placing the gate in the middle achieves a more balanced flow of epoxy resin. However, insufficient filling pressure in this configuration may result in an increase in the occurrence of air traps and weld lines. When multiple gates are used in the simulation, it is observed that the number of air traps does not decrease with an increase in the quantity of gates. Nonetheless, multiple gates promote a more balanced resin flow, although some convergence occurs, leading to the generation of numerous air traps at the convergence points. Additionally, excessive injection pressure can cause overflow and wire shifting at the window opening of the temperature and humidity sensor. In conclusion, the design of the gate system should carefully consider the structural characteristics of the product and the transfer molding process. It is evident that the gate system design plays a crucial role in the formation of air traps and weld lines. Therefore, a rational gate system design is vital to ensure both the yield and reliability of sensor products.

The Influence of the Thermal Stress on a Pressure Sensor in Integrated Weather Multi-Sensor Chip

Thermal Stress Analysis of MEMS Accelerometer Based on Finite Element Method

The design of a new integrated gas sensor array based on FEA

Analysis Of The Packaging Stresses In Monolithic Multi-Sensor

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Fabrication of Flexible Thermal Thin-film Sensor Array

Temperature Compensation of Micro Thermal Shear Stress Sensor

Sensing Elements Space Design of Hot-Film Sensor Array Considering Thermal Crosstalk

Influence of Size Effect on Dynamic Characteristics of Hot-film Wall Shear Stress Sensor.

Effects of Temperature and Residual Stresses on the Output Characteristics of a Piezoresistive Pressure Sensor

Investigation of Potting-Adhesive-Induced Thermal Stress in MEMS Pressure Sensor

Design and Fabrication of a MEMS Temperature and Pressure Integrated Sensor with Back-Inlet Package Structure

The Fabrication and Integration of a Novel Shear Stress Sensor Array and Its Wind Tunnel Test

Electronic Components Placement Optimization under Thermo-Mechanical Loads

Thermal Analysis of a Micro Shear-Stress Sensor

On Heat Insulation of Micro Thermal Sensor Using FEA

Residual Stresses in Monolithic Multi-Sensor Package

Study on Package Thermal Stress of Multi-ranged Micro-accelerometer

Measurement of Thermal Stress in Cob Packaging Structures

Research on Dust Effect for MEMS Thermal Wind Sensors

Investigation on the effect of the packaging-induced stress on the reliability of a MEMS sensor package