Abstract:There is great economic incentive in developing efficient catalysts to produce hydrogen or syngas by catalytic partial oxidation of methane (CPOM) since this is a much less energy-intensive reaction than the highly endothermic methane steam reforming reaction, which is the prominent reaction in industry. Herein, we report the catalytic behavior of nickel-based catalysts supported on different oxide substrates (Al2O3, CeO2, La2O3, MgO, and ZrO2) synthesized via wet impregnation and solid-state reaction. Furthermore, the impact of Rh doping was investigated. The catalysts have been characterized by X-ray diffraction, N2 adsorptiondesorption at -196°C, temperature-programmed reduction, X-ray photoelectron spectroscopy, O2-pulse chemisorption, transmission electron microscopy, and Raman spectroscopy. Supported Ni catalysts were found to be active for CPOM but can suffer from fast deactivation caused by the formation of carbon deposits as well as via the sintering of Ni nanoparticles (NPs). It has been found that the presence of Rh favors nickel reduction, which leads to an increase in the methane conversion and yield. For both synthesis methods, the catalysts supported on alumina and ceria show the best performance. This could be explained by the higher surface area of the Ni NPs on the alumina surface and presence of oxygen vacancies in the CeO2 lattice, which favor the proportion of oxygen adsorbed on defect sites. The catalysts supported on MgO suffer quick deactivation due to formation of a NiO/MgO solid solution, which is not reducible under the reaction conditions. The low level of carbon formation over the catalysts supported on La2O3 is ascribed to the very high dispersion of the nickel NPs and to the formation of lanthanum oxycarbonate, through which carbon deposits are gasified. The catalytic behavior for catalysts with ZrO2 as support depends on the synthesis method; however, in both cases, the catalysts undergo deactivation by carbon deposits.

Effects of preparation methods of ZrO2 support on catalytic performances of Ni/ZrO2 catalysts in methane partial oxidation to syngas

Effects Of Hydrothermal Conditions Of Zro2 On Catalyst Properties And Catalytic Performances Of Ni/Zro2 In The Partial Oxidation Of Methane

Regulating the Microenvironments and the D-Band Center of Hierarchical Nimos/Ts-1 Catalyst by Zro2 to Enhance the Hydrodesulfurization Performance of Dibenzothiophene

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Nickel‐Catalyzed Dry Reforming of Methane Via Modulating the Zirconia Shapes

Influences of preparation methods of ZrO2 support and treatment conditions of Cu/ZrO2 catalysts on synthesis of methanol via CO hydrogenation

Impact of Preparation Methods on the Performance of Cu/Ni/Zr Catalysts for Methanol Decomposition

Influences Of Reaction Conditions On Steam Reforming Of Methane Over Ni/Zro2 Catalyst.

Effects of ZrO2/Al2O3 properties on the catalytic activity of Pd catalysts for methane combustion and CO oxidation

Effects of Zr Addition on the Performance of the Pd-Pt/Al 2 O 3 Catalyst for Lean-Burn Natural Gas Vehicle Exhaust Purification

Catalytic Methanation of Syngas over Ni-based Catalysts with Different Supports

Influence of CeO2-ZrO2 and α-Al2O3 on methane partial oxidation over Ni catalyst

Mesoporous Ce-Zr Solid Solutions Supported Ni-based Catalysts for Low-Temperature CO2 Methanation by Tuning the Reaction Intermediates

Influence of Supports on Catalytic Performance and Carbon Deposition of Palladium Catalyst for Methane Partial Oxidation

Effect of preparation method on the hydrogen production from methanol steam reforming over binary Cu/ZrO2 catalysts

The Influence of the Preparation on the Catalytic Performance of Cu/ZrO2 for the Steam Reforming of Methanol

Effect Of Preparation Method On Catalytic Performance Of Cuo-Ceo2/Zro2 For Co Oxidation

Methane conversion to syngas over Ni/Y2O3 catalysts - Effects of calcination temperatures of Y2O3 on physicochemical properties and catalytic performance

Effect of crystallization mode of hydrous zirconia support on the isomerization activity of Pt/WO3–ZrO2

Partial Oxidation of Methane to Syngas Over Nickel-Based Catalysts: Influence of Support Type, Addition of Rhodium, and Preparation Method

Effect of Support Composition on Catalytic Performance of Ptsn/Zsm-5 Catalyst for Propane Dehydrogenation