Abstract:Innovation in comminution is expected to continue unabated to address the inefficiencies that are inherent in comminution circuits. The rotary offset crusher (ROC) is a new comminution device with a promising performance potential in terms of throughput due to the enhanced speed of transportation induced by the centrifugal force of the discs. However, the processes driving the comminution of particles trapped in the conical space between the two discs of the crusher are not fully understood. To gain a better insight into the comminution process in this device, discrete element modeling (DEM) simulations were conducted to study the breakage of a single particle for the crusher operated under two different dynamic conditions, i.e., (1) a stationary top disc and (2) both discs rotating at the same speed. For both scenarios, the speed of the discs was varied between 550 and 2350 rpm. Experimental testwork was also conducted with the laboratory prototype to generate the data that were used to calibrate the breakage parameters of the Ab × t10 breakage model. Simulations were performed using polyhedral UG2 ore particles that were generated with the in-built particle generator in the DEM simulator. The simulated ROC, which is operated with both discs rotating, outperformed the ROC with a stationary top disc in terms of the specific input energy and throughput. The crusher with a stationary top disc is characterized by high shear forces (suggesting a higher wear rate), specific input energies greater than 1 kWh/t, and low throughputs (<50 kg/h). The ROC operated with a stationary disc is not recommended for hard rock applications due to expected excessive wear of crushing surfaces and higher energy consumption. The freewheeling discs are recommended, but there is scope to optimize the crusher performance in terms of the power draw, size reduction, and throughput by manipulating the difference between the speeds of the discs. There is also scope to optimize the crusher performance when it is simulated with many particles. Once the full performance potential of the ROC is established, it will then be important to benchmark it against the existing crushers in the minerals industry as well as other industries where crushers are used.

Study on Main Butt Ends Load of Vertical Shaft Impact Crusher

Dynamic Analysis of Tip Set Extra Hard Load of Vertical Shaft Impact Crusher

Research on the Load Distribution of Throwing Ends in Vertical Shaft Impact Crusher

Wear of Throwing End of Vertical Shaft Impact Crusher

Rock-Breaking Mechanism Study of Axial and Torsional Impact Hammer and Its Application in Deep Wells

DEM Simulation of an Impact Crusher Using the Fast-Cutting Breakage Model

The Geometrical Model of Vertical Shaft Impact Crusher Rotor System

Wear Law and Parameter Optimization Study on the Split Cone of a Vertical Shaft Impact Crusher

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

Simulation Analysis for Rotor’s Strength of Impact Crusher

The Crushing Distribution Morphology of a Single Particle Subjected to Rotary Impact

Analysing the Influence in Real-Time Calculation Fatigue Consume Caused by Model Layer of Turbing Rotor

Vertical Shaft Impact Crusher Wear and Anti-Wear Measures

Analyse Rotor Dynamics of Agitating Shaft with the Finite Element Method

Rotor strength and critical speed analysis of a vertical long shaft fire pump connected with different shaft lengths

FEM Simulation Analysis on the Impact Force of Impact Crusher

Analysis of vertical roller mill performance with changes in material properties and operating conditions using DEM

Research on the Force Control System of Rotary Crusher Loading Testbed

Discrete Element Modeling of the Breakage of Single Polyhedral Particles in the Rotary Offset Crusher

Study on the Influence Law of Micro-Scale Abrasive Wear on a Wind Turbine Brake Pad

Crushing characteristics and performance evaluation of iron ore in a cone crusher: A numerical study