Abstract:Zr65Al7.5Ni10Cu12.5Zn5 and Zr65Al7.5Ni5Cu17.5Zn5 metallic glasses, which were obtained by adding Zn to the well-known glass-former Zr65Al7.5Ni10Cu17.5, were prepared by a melt-spinning method and the crystallization process was studied by differential scanning calorimetry (DSC), X-ray diffraction and transmission electron microscopy. Two exothermic peaks were observed in the DSC curves. The low temperature one corresponds to the simultaneous precipitation of an icosahedral quasicrystalline phase (I-phase) and the face centered cubic Zr2Ni (FCC–Zr2Ni) phase in the Zr65Al7.5Ni10Cu12.5Zn5 alloy. The initial precipitate for the Zr65Al7.5Ni5Cu17.5Zn5 alloy is a single I-phase. Since an I-phase does not occur in the crystallization process of Zr65Al7.5Ni10Cu17.5 metallic glass, the present results demonstrate that the addition of Zn is effective in promoting the precipitation of an I-phase, in addition to the previously reported noble metals. Further annealing leads to the precipitation of other stable crystalline phases, indicating the metastable character of the I-phase and the FCC–Zr2Ni phase. The reason for the change in the crystallization process caused by the addition of Zn was discussed on the basis of the chemical affinity and atomic radius of the constituent elements.

A study of the glass forming ability in ZrNiAl alloys

Composition Optimization of the NiZrYAl Glass Forming Alloys

An ab initio simulation and experimental studies of the glass-forming ability and properties of Al86Ni(14-x)Zrx (x = 1∼7) alloys

Glass-Forming Ability and Thermal Properties of Al70Fe12.5V12.5X5(X = Zr, Nb, Ni) Amorphous Alloys via Minor Alloying Additions

The Relation Between Formation of Compounds and Glass Forming Ability for Zr–Al–Ni Alloys

Unusual Solidification Behavior of a Zr–Cu–Ni–Al Bulk Glassy Alloy Made from Low-Purity Zr

Effect of Repeated Melting of the Ingots on the Glass-Forming Ability of Zr-Based Alloys

The Relations Between ΔT and the Glass Forming Ability of Bulk Amorphous Zr–Cu–Ni–Al–Hf–Ti and Zr52.5Cu17.9Ni14.6Al10Ti5 Alloys

Glass-forming ability and corrosion resistance of Zr-based Zr-Ni-Al bulk metallic glasses

Glass Forming Ability and Primary Crystallization Behavior of Al–Ni–Ce Alloys

Formation of a Ni- and Be-free Zr-based glassy alloy in centimeter scale

The effect of minor alloying on the glass forming ability and crystallization reaction of Ti32.8Zr30.2Cu9M5.3Be22.7 (M=Fe, Co, and Ni) bulk metallic glass

Glass-Forming Ability and Mechanical Properties of the Ternary Cu-Zr-Al and Quaternary Cu-Zr-Al-Ag Bulk Metallic Glasses

Formation and Compressive Properties of A Ni-Ti-Zr-Al-Cu-Si Amorphous Alloy

Effect of Fe on the glass-forming ability, structure and devitrification behavior of Zr-Cu-Al bulk glass-forming alloys

Effect of microalloying on glass-forming ability and crystallization kinetics of Zr52.5Cu17.9Ni14.6Al10Ti5 alloy

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Structural Properties and Thermal Stability of Glassy (Zr<sub>.65</sub>Al<sub>.075</sub>Cu<sub>.175</sub>Ni<sub>.1</sub>)<sub>100-x</sub>Fe<sub>x</sub> (x≤20) Alloys Prepared by Mechanical Alloying

Glass-forming Ability and Thermal Stability of Fe-Co-Ni-Zr-Mo-W-B Bulk Amorphous Alloys

Study on isothermal crystallization kinetics of Zr55.7Cu22.4Ni7.2Al14.7 bulk amorphous alloy

Effect of Zn Addition on the Crystallization Process in Zr65al7.5ni10cu17.5 Metallic Glass