Abstract:The increasing scarcity of natural sands has led to a growing preference for manufactured sand in the production of construction materials in response to sustainable development. However, existing research typically applies it to ordinary concrete, its application in advanced concrete still remains relatively limited to date. In this study, manufactured sand was used as aggregate to prepare the eco-friendly ultra-high performance concrete (UHPC). To further improve the effectiveness of solid waste management and alleviate its impact on the environment, the feasibility of ecological utilization of recycling stone powder (SP), a by-product from manufactured sand industry, as partial substitutes for cementitious materials was explored. The fresh and hardened properties, microstructural characteristics, environmental and economic implications were evaluated. Results indicated that the introduction of SP considerably enhanced the rheological properties and reduced the exothermic peak temperature of UHPC paste. With the increase of SP, a first increasing and then decreasing trend was seen in flowability. An equivalent or slightly improved level of mechanical strength was revealed at low SP content (i.e., 10%). Different lithological SP was found to enhance the toughness and suppress the early shrinkage of UHPC. Incorporating SP increased the total pore volume and refined the distribution of pore sizes, and could also change the morphology of hydration products and Si/Ca ratio of interfacial transition zone. Additionally, the lowest unit compressive strength costs were achieved at the substitution of 20%, 10% and 20% for granite, tuff and limestone mixtures, and the carbon emissions could be lowered by 26.9% compared with traditional UHPC when 30% of SP was involved, showing excellent economic and environmental benefits.

Trials on a Zircon Sand Substitute for Surface Layer in Shell-making

Recycling Stone Powder As a Partial Substitute for Cementitious Materials into Eco-Friendly Manufactured Sand Ultra-High Performance Concretes: Towards Cleaner and More Cost-Effective Construction Production

Laboratory Study on the Sintering Behavior of Zircon‐Based Ladle Filler Sands

Trials on a New Quick-drying and Enhanced Silica Sol

Effect of zircon addition on the sintering of chromite-based ladle filler sands

Development of Advanced Coatings and Surface-sand Preventing Metal Penetration in Large-size Steel Castings by Furan Resin Sand Process

Research and Application on Alcohol-Base Resisting Penetration Sand State Coating Substituting for Zircon Coating

Interactions Between TiAl and ZrO2 Face Coat During Centrifugal Investment Casting

Investigation of Fused Alumina Based-Mold Facecoats for DZ22B Directionally Solidified Blades

Development of a New Ferrous Aluminosilicate Refractory Material for Investment Casting of Aluminum Alloys

Iron and Steel Castings and Core Production Results from Finer Grades of Chromite Sand in Shell Applications

Sintering Behavior of New Chromite-Alumina Mixed Ladle Filler Sands for High Mn-High Al Steel Grades

Facile and Economical Preparation of SiAlON-Based Composites Using Coal Gangue: from Fundamental to Industrial Application

Study and Application on No Bake Phosphate High Chromite-Corundum Sand

On the Efficiency of Laser Alloying of Grey Cast Iron with Tungsten and Silicon Carbides

A novel approach for the resource utilization of zinc-bearing dust and sludge via the blast furnace main trough

Evolution of interfacial structure and fracture behavior in ZL702A/SUS304 compound castings with different surface treatments

Effect of Carbon on Sintering Behavior of Chromite‐Based Ladle Filler Sands

Characterization and mechanism analysis of interaction between Inconel 713C superalloy and a novel crucible-shell "integrated" mold

Preparation and characterization of low-cost refractories for aluminum-melting-furnace linings from ferrotitanium slag

Research on frozen sand mold casting technology for complex thin-walled aluminum alloy castings