Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Effect of Carbon on Sintering Behavior of Chromite‐Based Ladle Filler Sands

Sintering Behavior of New Chromite-Alumina Mixed Ladle Filler Sands for High Mn-High Al Steel Grades

Effect of zircon addition on the sintering of chromite-based ladle filler sands

Mechanism Study of the Blocking of Ladle Well Due to Sintering of Filler Sand

Effect of Chromite-Silica Sands Characteristics on Performance of Ladle Filler Sands for Continuous Casting

Laboratory Study on the Sintering Behavior of Zircon‐Based Ladle Filler Sands

Effect of silica concentration on degree of sintering of chromite-silica ladle well filler sand based on South African raw materials

Effect of furnace atmosphere on sintering process of chromium-containing steel via powder metallurgy

Experimental Study on Effect of Flux Addition on the Sintering Harmful Gas Emission

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

Effect of CO2 treatment on the microstructure and properties of steel slag supplementary cementitous materials

Free Opening Performance of Steel Ladle as a Function of Filler Sand Properties

Experimental Study on the Resource Utilization of Carbide Slag in Iron Ore Sintering Process

Effect of Carbonation Treatment on the Strength and CO2 Uptake Rate of Composite Cementitious Material with a High Steel Slag Powder Content

Effect of Moisture on the Granulation and Sintering Characteristics of Sinter Materials with Carbide Slag As a Flux

Laboratory investigation on quantitative effect of ladle filler sands on the cleanliness of a bearing steel

Assessing Stainless Steel Swarf Effect on Limonitic Laterite Sintering Process

Effect of Coating Structure of Granulated Quasi‐fuel Particles in Iron Ore Sintering