Abstract:Methyl acetate (MA) hydrogenation to ethanol was investigated over SBA-15 supported copper (Cu/SBA-15) catalysts prepared by different methods, including impregnation, deposition precipitation, and homogeneous deposition precipitation. The catalysts were characterized by means of the Brunauer-Emmett-Teller method, X-ray diffraction, transmission electron microscopy, temperature-programmed reduction and X-ray photoelectron spectroscopy. Of the three catalysts, it was found that the Cu/SBA-15 catalyst prepared by the homogeneous deposition precipitation method has the smallest particle size, and the appropriate Cu+/(Cu+ + Cu-0) molar ratio of 53.5%. The high dispersion of the active components, and the synergetic effect between Cu-0 and Cu+ contributed to the high activity of Cu/SBA-15 prepared via the homogeneous deposition precipitation method. A MA conversion of 93.6% with an ethanol selectivity of 98.5% was obtained for MA hydrogenation in methanol solution under mild reaction conditions. Both of these values were much higher than those obtained over catalysts prepared by the other two methods. The catalyst still maintained good performance in the co-hydrogenation of acetic acid and MA in methanol solution. A high MA conversion of 99.5% and an ethanol selectivity of 99.5% were obtained for pure MA hydrogenation over the best catalyst. It was found that methanol solution inhibited the conversion of MA, and suppressed the side reaction of MA trans-esterification with the product ethanol at higher LHSV.

Characterization of Cu/SiO2 Catalyst and Its Performance in Hydrogenation of Ethyl Acetate to Ethanol

Selective Hydrogenation of Dimethyl Maleate to Tetrahydrofuran over Cu/SiO2 Catalyst: Effect of Cu+ on the Catalytic Performance

Influence of Catalyst Structure on Performance of Cu/Sio2 in Hydrogenation of Methyl Acetate

Effect of supports on performance of Cu-based catalysts for hydrogenation of ethyl acetate to ethanol

Performance of SiO 2 –TiO 2 Binary Oxides Supported Cu–ZnO Catalyst in Ethyl Acetate Hydrogenation to Ethanol

Preparation and modification of Cu/SiO2 catalyst for hydrogenation of dimethyl oxalate to ethyl glycol

Gaseous Phase Hydrogenation of Ethyl Acetate Catalyzed by CuX/Mg-SiO2

Highly Active and Selective Cu/Sio2 Catalysts Prepared by the Urea Hydrolysis Method in Dimethyl Oxalate Hydrogenation

Cu/SiO2 Catalysts Prepared by the Ammonia-Evaporation Method: Texture, Structure, and Catalytic Performance in Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Effect of hydrothermal treatment on performance of Cu/SiO2 catalysts for hydrogenation of dimethyl oxalate to ethylene glycol

Effect of the Cu/SBA-15 catalyst preparation method on methyl acetate hydrogenation for ethanol production

Catalytic Performance and Reaction Pathways of Cu/SiO 2 and ZnO/SiO 2 for Dehydrogenation of Ethanol to Acetaldehyde

Effect of Initial Precipitation Temperature on the Structural Evolution and Catalytic Behavior of Cu/SiO2 Catalyst in the Hydrogenation of Dimethyloxalate

Process research on the catalytic hydrogenation of methyl acetate to ethanol

A Cu-SiO2 Catalyst for Highly Efficient Hydrogenation of Methyl Formate to Methanol

Highly Active Cu/SiO2 Catalysts for Hydrogenation of Diethyl Malonate to 1,3-Propanediol

Tailoring the Catalytic Performance of Cu/SiO2 for Hydrogenolysis of Biomass-Derived 5-Hydroxymethylfurfural to Renewable Fuels

Study of nano‐Cu/SiO2 catalysts for highly selective hydrogenation of acetophenone

Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Cu/Sio2 Catalysts

Co-production of Hydrogen and Acetaldehyde from Ethanol over a Highly Dispersed Cu Catalyst

Cu/Sio2 Catalysts Prepared by the Sol-Gel Method for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol