Abstract:Cu/SiO2 catalyst prepared by the ammonia-evaporation (AE) method is the potential preferred catalyst for hydrogenation of dimethyl oxalate (DMO) to ethylene glycol (EG). Although significant advancements have been obtained in the confirmation and influence factors of active species in the hydrogenation process, the relationship between the catalytic activity and the sensitive factors in the preparation or pretreatment process of the catalyst is still uncertain. In this paper, Cu/ZSM-5 catalysts for DMO hydrogenation to EG were prepared by the AE method using ZSM-5 molecular sieve with high silicon-alumina ratio (1500) as a support. The ZSM-5 support was pretreated by drying at 393 K for different hours and it was found that the surface hydroxyl group of the support had significant influence on the structure and catalytic hydrogenation performance of the prepared Cu/ZSM-5 catalyst. The distribution of surface hydroxyl groups could be significantly changed by pre-drying the carrier, which further resulted in the change of the copper dispersion and surface properties of subsequent copper-supported catalysts. With the decrease of hydroxyl content on the surface of the ZSM-5 support, the prepared reduced Cu/ZSM-5 catalyst possessed smaller Cu0 particles size, higher copper dispersion, higher surface area of Cu0 and Cu+ species, but weakened surface acidity of the catalyst, which resulted in the great improvement of the catalytic activity. The DMO conversion and EG selectivity could reach 100% and 93% even under the low reaction temperature at 448 K over the Cu/ZSM-5-24 catalyst (based on the ZSM-5 support pretreated by drying for 24 h). In addition, the catalytic activity did not show obvious change after 300 h of reaction, probably due to the low temperature reaction and suitable surface properties of the catalyst.Graphical Abstract

Performance of SiO 2 –TiO 2 Binary Oxides Supported Cu–ZnO Catalyst in Ethyl Acetate Hydrogenation to Ethanol

Strong Cu/ZnO Interfacial Interaction Induced by ZrO2 Promoter Suppressing the Ethanol Formation in Industrial Methanol Synthesis

CuZnCoOx Multifunctional Catalyst for in Situ Hydrogenation of 5-Hydroxymethylfurfural with Ethanol As Hydrogen Carrier

Enhanced Catalytic Performance for SiO2–TiO2 Binary Oxide Supported Cu-based Catalyst in the Hydrogenation of Dimethyloxalate

Catalytic Performance and Reaction Pathways of Cu/SiO 2 and ZnO/SiO 2 for Dehydrogenation of Ethanol to Acetaldehyde

A CuZn-BTC derived stable Cu/ZnO@SiO2 catalyst for ethanol dehydrogenation

Effect of supports on performance of Cu-based catalysts for hydrogenation of ethyl acetate to ethanol

Characterization of Cu/SiO2 Catalyst and Its Performance in Hydrogenation of Ethyl Acetate to Ethanol

Catalytic Performance and Texture of Teos Based Cu/Sio2 Catalysts for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Cu/SiO2 Catalysts Prepared by the Ammonia-Evaporation Method: Texture, Structure, and Catalytic Performance in Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

An Effective CuZn–SiO2 Bimetallic Catalyst Prepared by Hydrolysis Precipitation Method for the Hydrogenation of Methyl Acetate to Ethanol

Gaseous Phase Hydrogenation of Ethyl Acetate Catalyzed by CuX/Mg-SiO2

Ethylene glycol and ethanol synthesis from dimethyl oxalate hydrogenation on the Cu/ZnO/SiO2 catalysts

Cu/SiO2 catalysts prepared by different methods for hydrogenolysis of dimethyl oxalate to ethylene glycol

Highly Active and Selective Cu/Sio2 Catalysts Prepared by the Urea Hydrolysis Method in Dimethyl Oxalate Hydrogenation

Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Cu/Sio2 Catalysts

Effect of support for alcohol-hydrocarbon synthesis from syngas in Cu-based catalyst

Efficient Tuning of Surface Copper Species of Cu/SiO2 Catalyst for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Cu/Sio2 Catalysts Prepared by the Sol-Gel Method for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Cu/MgO as an Efficient New Catalyst for the Non-Oxidative Dehydrogenation of Ethanol into Acetaldehyde

Effect of Surface Hydroxyl Content of Support on the Activity of Cu/ZSM-5 Catalyst for Low-Temperature Hydrogenation of Dimethyl Oxalate to Ethylene Glycol