Abstract:Maleic anhydride (MAH) was grafted onto polypropylene (PP) film efficiently by means of introducing the electron donor monomer n -butyl vinyl ether ( n -BVE), under UV irradiation. The principal factors affecting surface photografting polymerization such as irradiation time, molar ratio of MAH to BVE, monomer concentration, photoinitiators, UV and solvents, were investigated systematically. The results show that the photografting of MAH/BVE is an effective approach to modify the surface property of the polymeric materials, and the photografting process is very efficient. The contact angle of the grafted surface against water could decrease from 87 ° to less than 20 ° within 40 s of the irradiation time. The grafting efficiency would reach the highest when the molar ratio of MAH to BVE was 1:1, which indicated that the formation of charge transfer complex (CTC) between the binary monomers was favorable to the photografting polymerization. Among the photoinitiators benzildimethylketal (BDK), benzophenone (BP) and isopropylthioxanthone (ITX), the sequence of grafting efficiency was BP>ITX>BDK. Far UV (200–300 nm) radiation played a decisive role in the photografting polymerization and high UV intensity could accelerate this process. The solvent with good affinity towards the substrates was favorable to increase the grafting efficiency, because the diffusion of monomer and photoinitiator to the liquid-solid interface could be swimmingly. FT-IR spectra confirmed that both MAH and BVE had been successfully grafted onto PP film.

Radiation-induced grafting polymerization of MMA onto polybutadiene rubber latex

Preparation and Characterization of MMA-BA-DMAEMA Terpolymer Latex

Simultaneous Graft Polymerization of Polypropylene with Maleic Anhydride and Butyl Acrylate

INFLUENCE OF MONOMER COMPOSITION ON THE CHAIN TRANSFER COEFFICIENT IN METHYL METHACRYLATE/BUTYL ACRYLATE RAFT COPOLYMERIZATION

Raft Grafting Polymerization of Mma/St from Surface of Silicon Wafer

Synthesis of EPDM-g-PMMA through atom transfer radical polymerization

Synthesis of Poly(IB‐co‐VBDC)‐g‐PMMA Via Photo‐initiated Free Radical Graft Polymerization

Radiation-induced Graft Polymerization of Maleic Acid and Maleic Anhydride Onto Ultra-Fine Powdered Styrene–butadiene Rubber (UFSBR)

ANCHORING OF AZO INITIATOR AND GRAFTING OF POLY(METHYL METHACRYLATE) ONTO NANAOMETER SILICA

Fundamental Study on Preparation Process and Structure Coutrol of PBA/PMMA

Graft copolymerization of butyl acrylate on MgO surface by radiation

Preparation of Poly (methyl Methacrylate)/nanometer Calcium Carbonate Composite by In-Situ Emulsion Polymerization

STUDY ON DIRECT RADIATION GRAFTING OF THERMO-SENSITIVE NIPAAm ONTO SILICONE RUBBER AND THE CHARACTERIZATION OF THE GRAFTED FILMS

Grafting copolymerization of N,N-dimethyacrylaminoethylmethacrylate (DMAEMA) onto preirradiated polypropylene films

MMA/DVB emulsion surface graft polymerization initiated by UV light.

Preparation of Poly(methyl Methacrylate)/ultrafine CaCO3 Composite Particles by In-Situ Dispersion Polymerization

In-Situ Heterogenous Polymerization of Methyl Methacrylateonto Nanometer Calcium Carbonate Particles

Synthesis and Characterization of Poly (N-Butyl Acrylate)-Poly (methyl Methacrylate) Latex Interpenetrating Polymer Networks by Radiation-Induced Seeded Emulsion Polymerization

Characterization of chemical structure and morphology of MCS graft terpolymer

Influence of the Degree of Grafting on the Morphology and Mechanical Properties of Blends of Poly(butylene Terephthalate) and Glycidyl Methacrylate Grafted Poly(ethylene‐co‐propylene) (EPR)

Surface Photografting Polymerization of Binary Monomers Maleic Anhydride and n -Butyl Vinyl Ether on Polypropylene Film I. Effects of Principal Factors