Abstract:This paper investigates the flow structure and flow pattern transition within a conical ribbed Taylor–Couette reactor (TCR), which is 4 mm in gap width and 200 mm in height, via particle image velocimetry (PIV) and numerical simulation methods. The effect of various parameters on the vortex structure and on flow transition, including the structural parameters of the ribs (rib spacing and rib width) and the operating parameters (Taylor number and axial Reynolds number), were investigated. Without axial flow, the ribbed TCR can control the flow structure while maintaining the symmetry of the flow field. Under certain conditions, a Taylor vortex pair can form between the ribs, with the down vortex rotating clockwise and the up vortex rotating counterclockwise. The axial dimension of the Taylor vortex can be controlled by adjusting the rib spacing, which can be summarized into four different conditions according to the size of the rib spacing. With axial flow, the axial Reynolds number greatly impacts the Taylor vortex structure within the ribbed TCR, and as the axial Reynolds number increases, the up vortex appears to be compressed and the down vortex appears to be stretched. The double vortex flow pattern between the ribs is eventually transformed into a single vortex. The critical axial Reynolds number for flow pattern transition is defined and correlated with the Taylor number and rib spacing. The results show that the critical axial Reynolds number is positively proportional to the Taylor number and is inversely proportional to rib spacing. The empirical correlation equation developed in this study shows strong predictive power and is validated using the experimental results. Overall, this study provides a comprehensive understanding of the flow structure and pattern transition within a ribbed TCR and lays the foundation for the further optimization of TCR design.

FLOW VISUALIZATION OF THE LONGITUDINAL VORTICES IN THE DISCRETE DOUBLE INCLINED RIBS TUBE

Visualization of longitudinal vortex flow in an enhanced heat transfer tube

3D flow visualization and tomographic particle image velocimetry for vortex breakdown over a non-slender delta wing

Numerical flow visualization of a mixing layer

Turbulent flow and heat transfer in discrete double inclined ribs tube

Experimental and Numerical Flow Visualizations of Mixed Convection with Flow Reversal in a Horizontal Channel with Constant Wall Temperature

Numerical Investigation on Two Degree-of-freedom Flow-Induced Vibration of Three Tandem Cylinders

Observation of Flow Around a Vertical Cylinder in a Parallel Channel.

Visualization and Analysis of Longitudinal Vortices at Curved Walls of 2D Laminar and Turbulent Channel Flows

Investigation on Visualization Test Methods for Flow Field Downstream Spacer Grids

Viscoelastic flow in rotating curved pipes

THE OUTSIDE TUBE HEAT TRANSFER PERFORMANCE OF THE DISCRETE DOUBLE INCLINED RIBS TUBE

Experimental Study of Flow Structure Characteristics for a T-Junction Duct with Horizontal Vanes

Direct numerical simulation of turbulent duct flow with inclined or V-shaped ribs mounted on one wall

[Liquid Flow Field Measurement in a Tube with a Combination of Stenosis and Bifurcation].

Flow-induced Vibrations of Two Staggered Circular Cylinders at Low Reynolds Number

Visualization And Piv Measurements Of The Near Wall Structure In A Turbulent Pipe Flow

Flow in a Taylor–Couette Reactor with Ribbed Rotors

3-D Flow Characteristics Of Asymmetric Vortices Over An Ogive-Cylinder And Its Structural Model

Flow Pattern Transition and Void Fraction Prediction of Gas–liquid Flow in Helically Coiled Tubes

Experimental investigation of the flow characteristics within a vortex tube with different configurations