Abstract:Carbonization is the first step in the heat and pressure treatment (pyrolysis) of composites in preparing carbon-carbon parts. These find many uses, including aircraft brakes, rocket nozzles and medical implants. This paper describes the acoustic emissions (AE) from various stages of the manufacturing process of carbon-carbon composites. This process involves carbonization at a high temperature and this results in both thermal expansion and volume change (due to pyrolysis in which a sacrificial polymer matrix is converted to carbon). Importantly the resultant matrix is porous and has a network of small intra-lamina cracks. The formation of these microcracks produces AE and this paper describes how this observation can be used to monitor (and eventually control) the manufacturing process. The aim is to speed up manufacture, which is currently time-consuming. The first section of the paper describes the design of unimodal waveguides to enable the AE to propagate to a cool environment where a transducer can be located. The second part of the paper describes various experimental observations of AE under a range of process conditions. In particular, this paper presents a technique based on detecting acoustic emissions and (1) uses wire waveguides to monitor parts within the autoclave to 800 degrees C, (2) monitors microcracking during pyrolysis, (3) uses a four-level threshold to distinguish between low- and high-amplitude cracking events, (4) recognizes the occurrence of harmful delaminations, and (5) guides the control of the heating rate for optimum efficiency of the pyrolysis process. In addition, supporting data are presented of in situ measurements of porosity, weight loss, cross-ply shrinkage, and mass spectroscopy of gases emitted. The process evolution is illustrated by the use of interrupted manufacturing cycle micrographs obtained by optical, scanning acoustic (SAM) and scanning electron (SEM) microscopy. The technique promotes in-process monitoring and control but also contributes to current understanding of pyrolysis.

Acoustic Monitoring of Carbon-Film Formation by Laser-Induced Chemical-Vapor Deposition

Monitoring of Formation Rates of Thin-Films in Laser-Induced Chemical Vapor-Deposition

Optical Monitoring of Laser-Induced Plasma Derived from Graphite and Characterization of the Deposited Carbon Film

Deposition of nano-diamond-like carbon films by an atmospheric pressure plasma gun and diagnostic by optical emission spectrum on the process

Laser-induced Chemical Vapor Deposition Diamondlike Film

A Field Emission Study of the Critical Parameters of Amorphous Carbon Films Deposited on a Variety of Carbonaceous Substrates

A New Reactive Pulsed Laser Ablation Technique for the Deposition of Hard Carbon and Carbon-Nitride Thin Films

Diamond-like Carbon Thin Films Prepared by ECR Argon Plasma Assisted Pulsed Laser Deposition

Spectroscopic Study on the Evolution of Graphite Ablation Plume in ECR Argon Plasma During the Deposition of Diamond-Like Carbon Films

Pulsed Laser Deposition of Hydrogenated Amorphous Carbon Films from A Polymeric Target

Pulsed Laser Photodissociation of Chromium Hexacarbonyl at 308 Nm: Simultaneous Monitoring of Optical and Acoustic Emissions

Diagnostics of CH/sub 4/ plasmas used for diamond-like carbon deposition

Self-organized subwavelength ripple by nanosecond laser induced chemical vapor deposition

Laser-assisted Chemical Vapor Deposition of Diamond Films

Diamond-Like Carbon Thin-Film Deposition Using A Magnetically Confined Rf Pecvd System

Research on Excimer Laser Induced Chemical Vapor Deposition of Diamond Films

Deposition of Diamond-Like Carbon Film by Ultrashort Pulsed Excimer Laser

Monitoring the deposited energy in laser-induced plasmas with an acoustic approach

Acoustic characteristics of laser-induced plasmas from the forming dynamics perspective

Acoustic emission technique for monitoring the pyrolysis of composites for process control

Investigation of Inductively Coupled Ar and CH4/Ar Plasmas and the Effect of Ion Energy on DLC Film Properties