Abstract:Characterizing the behavior of ductile metals at high strains is essential in various fields. In the case of thin sheets, rectangular cross-section specimens are used to characterize these materials, typically by tensile tests. Unlike cylindrical specimens, flat ones pose additional challenges for the hardening characterization at high strains, especially in the post-necking phase, which, for many high-strength steels, may cover most of the plastic strain range. After the onset of global necking, the rectangular cross-sections tend to distort with respect to their original shape, as their edges progressively curve and bulge inward. The localized necking occurring after the global one in thinner specimens, further distorts the necked zone. Additionally, sheet metals usually exhibit anisotropic characteristics that affect the derivation of the stress–strain curve and need to be dealt with. No exact method exists for the stress–strain characterization of ductile thin sheets at high strains from tensile tests. Although several approximate methods are available in the literature, they either discard the post-necking range or require highly advanced and complex experimental setups not suitable for industrial applications (e.g., 3D DIC). Then, this work proposes a relatively simple methodology for the experimental characterization of anisotropic thin sheet metals through tensile tests on rectangular cross-section specimens that delivers the true stress–strain curve of the material, extended over the necking range and up to fracture, accurately assessing the anisotropy and the distortion of the neck section. The proposed methodology, employing a standard single-camera experimental setup, is illustrated here, referring to four different steels for automotive applications with reference to a single material orientation; it is intended as representative of the repeated procedure involving tensile tests along 3 or more material directions in order to describe the whole anisotropic plastic response. A detailed comparison between the novel methodology and four other common approaches is carried out, highlighting the differences and the enhanced capabilities of the novel one proposed.

Necking in plane strain under bending with constant tension

Ductility Factors of Steel Plates Subjected to Non-Uniform Compression and Section Classification for Seismic Design

Necking of thin-walled cylinders via bifurcation of incompressible nonlinear elastic solids

Porous plasticity modeling of local necking in sheet metals

Material Aspects of Dynamic Neck Retardation

INFLUENCE OF STRAIN HARDENING ON BUCKLING/PLASTIC STRENGTH OF PLATES

Plastic instability under plane stress

Simplified method to identify full von Mises stress-strain curve of structural metals

Nonlinear axisymmetric bending analysis of strain gradient thin circular plate

A closed-form structural stress-strain relation and implications on plastic design limits in codes and standards

Axisymmetric necking versus Treloar-Kearsley instability in a hyperelastic sheet under equibiaxial stretching

An Enhanced Approach for High-Strain Plasticity in Flat Anisotropic Specimens with Progressively Distorting Neck Sections

Multiple kinking of a tensile crack in the brittle multilayered media abundant with closely-parallel weak interfaces

Necking after extensional filament stretching of complex fluids and soft solids

Dynamic tensile behavior and constitutive model of a novel high-strength and high-toughness plate steel

A homogenized bending theory for prestrained plates

Simulation Of Elastoplastic Fracture Of A Center Cracked Plate

Stress–strain curves of metallic materials and post‐necking strain hardening characterization: A review

Effects of Strength Difference and Intermediate Principal Stress on Plane Strain Elastic–plastic Bending of a Curved Beam

Analytical Characterizations of Crack Tip Plastic Zone Size for Central-Cracked Unstiffened and Stiffened Plates under Biaxial Loading

An Energy Method for the Bifurcation Analysis of Necking