Abstract:Water mist is considered as a potential alternative to halon in fire extinguishing applications. However, penetration is remarkably reduced due to the rapid decay of momentum in the process of water mist movement, which makes it difficult for water mist to reach the flame zone to extinguish the fire. To effectively improve the momentum of the water mist, a novel water mist system namely co-flow jet water mist system was proposed. A configuration in which a co-flow jet was induced to control the motion of water mist. A three-dimensional simulation was performed on the gas–liquid flow in this system. The Realizable k-ε model coupled with the discrete phase model (DPM) was employed for high-speed co-flow jet and laden droplets respectively. Simulations were focused on the interaction of the gas–liquid phase. It was found that the potential core length of the co-flow jet was increased owing to the injection of droplets, but the turbulence intensity and the attenuation of the axial velocity of the co-flow jet were reduced by the broken droplets. In addition, the droplets produced by the atomizer were broken into uniform small ones under the action of co-flow jet, and the spatial distribution of droplets was also changed, more importantly, the momentum of droplets was increased effectively. The droplet size as well as spatial distribution and momentum was related to the gas–liquid mass ratio (GLR). The GLR should be increased as much as possible to enhance the performance of the co-flow jet once the required concentration to extinguish a fire is achieved. This technique is helpful to the popularization and application of a water mist system.

Design and Simulation of a Water Mist Nozzle Base on Fluent

EMULATIONAL AND EXPERIMENTAL STUDY OF NEW WATER MIST SPRAY NOZZLE FOR FIRE SUPPRESSION

Measurement of Atomization Characteristics on Water Mist Fire Suppression Nozzle

Analysis of the Flow Characteristics of Diffuser/Nozzle Based on MEMS

The Numerical Simulation of Extinguish Pool Fire by Water Mist

Portable High-Pressure Direct Atomize Water Mist Fire Suppression System

Two-stage atomizing high pressure water mist spray head for fire suppression

Study on the Atomization Characteristics of High-pressure Nozzle with an In-line Distributor

Study on Fire-Fighting Experiment of Portable Water-Mist Fire Suppression System

Development of High-Pressure Single-Fluid Water Mist Fire Protection System

Assessment of a Method to Enhance the Momentum of Water Mist: Co-Flow Jet Water Mist System

A study on the performance of a swirling–straight composite nozzle

Experimental and Numerical Simulation Studies on the Atomization Characteristics of the Internal Mixing Nozzle and Its Field Application

Exploitation and Experimentation of Low Pressure Intermediate Flow Rate Centrifugal Water Spray Nozzle

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Mechanism Insight of Shielded Methane Non-Premixed Jet Flame Extinction with Water Mist: OH-PLIF Visualization and Quantitative Analysis of Critical Fire Extinguishing

Numerical Simulation of Fire Suppression in Stilted Wooden Buildings with Fine Water Mist Based on FDS

Multi-objective parameters optimization design of self-excited oscillation pulsed atomizing nozzle

Numerical simulation of water mist pressure effects on pool fire suppression

Numerical Study and Structural Optimization of Impinging Jet Heat Transfer Performance of Floatation Nozzle

Numerical and experimental study of the effects of tangential to axial velocity ratio and structural parameters inside the nozzle on spray characteristics