Abstract:High-power permanent magnet synchronous motor (PMSM) has great application potential in the field of traction or propulsion. Since the compact structure and high heat load density of PMSM, heat dissipation conditions introduce new challenges and opportunities for further improvement of its power, efficiency and reliability. In this paper, a new gas–liquid two-phase jet cooling system (GLCS) for PMSM is proposed. The flow and heat transfer characteristics of GLCS are studied numerically. The effects of different factors on heat and mass transfer characteristics were studied. It lays a foundation for the development of thermal analysis and thermal design of high power density permanent magnet synchronous motors with wide application prospects in high-speed rail, urban rail and electric vehicle traction systems. The results show that the surface temperature of stator and rotor can be below 350 K, which proves the heat dissipation capacity of the cooling system. The closer the jet area is to the surface of the rotor, the smaller the velocity is. The surface temperature of stator and rotor is distributed in a W-shape. The effect of liquid volume fraction on different surfaces is different. On the rotor surface, with the increase of liquid volume fraction, the cooling effect is enhanced, while on the stator surface, the cooling effect is weakened. When the rotating speed is 4200 r min −1 , the jet cone angle is less than 60°, which can ensure the heat dissipation capacity of the cooling system. The axial influence distance of jet velocity on the surface temperature of rotor is 40 mm. The number of circumferential nozzles is 3 and the number of axial nozzles is 6, which can ensure the best heat dissipation capacity of GLCS.

Study on liquid-jet cooling and heating of the moving SMA actuator

Two-dimensional Heat Transfer of Jet Impinging on Shape Memory Alloy Actuator

EXPERIMENT AND NUMERICAL SIMULATIONS ON HEAT TRANSFER OF LIQUID-JET IMPINGING TINI SMA AT PERIODIC BOUNDARY CONDITION

Numerical Investigation on Hydrodynamics and Heat Transfer of Highly Viscous Fluid in Sulzer Mixer Reactor

Transient thermal response of SMA actuator under gas-jet impingement

Research on temperature controlling for GMA based on direct liquid cooling

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

The Design of Temperature Control System in Giant Magnetostrictive Actuator

Novel Microfluid Actuator Based On Marangoni Effect

Design and Experiment of An SMA Flexible Actuator with Fluid-channels Cooling

Experimental and Numerical Investigation of Thermoelectric SMA Actuator of Micro Thermal Louvers

THE DESIGN AND OPTIMIZATION OF SHAPE MEMORY ALLOY ACTUATOR 1)

Experimental Study and Modeling of a Differential SMA Spring Actuator

Experimental and Numerical Study on Liquid Film Cooling Performance under Heated Wall Condition

Flow Mechanism and Heat Transfer Characteristic of Sweeping Jet Impinging on Confined Concave Surfaces

Structural design for adaptive heat transfer enhancement

Numerical simulation of jet cooling method inside air gap in a high-power permanent magnet synchronous motor

Further Investigation on the Flow and Heat Transfer Mechanism of Single-Jet Film Cooling Based on Hybrid Thermal Lattice Boltzmann Method

SMA actuator design and analysis for forebody active disturbance flow control on slender body

Ablation and Molten Layer Flow Simulation for Plate Model of SiO 2f /SiO 2 Composite Material Using Particle Method

A numerical study on multi-nozzle spray cooling of downward-facing heater surface