Abstract:Synthetic jet, potentially useful in electronic cooling, is numerically studied considering various waveforms for the purpose of heat transfer enhancement and compare to the corresponding steady air jet. In the present study, sinusoidal, rectangular and triangular synthetic jets are applied to a confined two-dimensional slot jet impinging on a heated plate adopting SST/k-omega turbulence model. The jet frequency is varied from 10 to 400 Hz for Reynolds numbers (Re) in the range of 1553-7766 (Strouhal number 0.012 <= St <= 2.4) and jet-to-surface distances ranging from 2 to 8. Generally, the cooling performance is enhanced by increase in Re and with the increase in frequency and H/W, the cooling performance shows a first increase and then decrease trend. Results of simulation indicate that conditions at the turning frequency correspond to critical St = 0.24-0.48 have higher heat transfer rate than other cases at the same Re. When St < 0.06, the heat transfer performance of rectangular jets can be better than the other two jets. When St is close to the critical St, the comparison of heat transfer enhancement is that triangular jets > sinusoidal jets > rectangular jets. Time sequence of streamline and velocity contour image is presented to further explain this phenomenon. Moreover, most conditions show good heat transfer enhancement compare to the corresponding steady jet except conditions in which St is too high (St > 1.2) or H/W is too low, or H/W is too large (H/W = 2 or H/W = 8). The maximum heat transfer enhancement coefficient of synthetic jets is found to be 74.7% higher than that of the corresponding steady jet. (C) 2018 Elsevier Ltd. All rights reserved.

Two-dimensional Heat Transfer of Jet Impinging on Shape Memory Alloy Actuator

Transient thermal response of SMA actuator under gas-jet impingement

Study on liquid-jet cooling and heating of the moving SMA actuator

EXPERIMENT AND NUMERICAL SIMULATIONS ON HEAT TRANSFER OF LIQUID-JET IMPINGING TINI SMA AT PERIODIC BOUNDARY CONDITION

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

THE DESIGN AND OPTIMIZATION OF SHAPE MEMORY ALLOY ACTUATOR 1)

Structural design for adaptive heat transfer enhancement

Numerical Simulation of Heat Transfer and Fluid Flow of a Non-Equilibrium Argon Plasma Jet with Confined Wall

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Experimental and Numerical Investigation of Thermoelectric SMA Actuator of Micro Thermal Louvers

Thin liquid film flow and heat transfer under spray impingement

Adaptive Heat Flux Control in Scramjet Cooling Channel

Numerical Investigation of Heat Transfer Characteristics of Impinging Synthetic Jets with Different Waveforms

Experimental Study and Modeling of a Differential SMA Spring Actuator

Flow Mechanism and Heat Transfer Characteristic of Sweeping Jet Impinging on Confined Concave Surfaces

Numerical Study of Impinging Jets Heat Transfer with Different Nozzle Geometries and Arrangements for a Ground Fast Cooling Simulation Device

Thermo-aeroelastic analysis of triangular composite plate with embedded shape memory alloy at supersonic flow

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

An Experimental and Computational Heat Transfer Study of Pulsating Jets

Modeling and Experimental Study on a New Electric-thermal Heating Method for Shape Memory Alloy Wire Actuators

Comparative Study Of Impinging Jet Array Heat Transfer On A Flat Plate Cooled By Superheated Steam And Air