Abstract:Low emittance (sub-100 nm rad) measurement of electron beams in plasma accelerators has been a challenging issue for a while. Among various measurement schemes, measurements based on single-shot quad-scan using permanent magnetic quadrupoles (PMQs) has been recently reported with emittance as low as similar to 200 nm Weingartner (2012 Phys. Rev. Spec. Top. Accel. Beams 15 111302). However, the accuracy and reliability of this method have not been systematically analyzed. Such analysis is critical for evaluating the potential of sub-100 nm rad emittance measurement using any scheme. In this paper, we analyze the effects of various nonideal physical factors on the accuracy and reliability using the PMQ method. These factors include aberration induced by a high order field, PMQ misalignment and angular fluctuation of incoming beams. Our conclusions are as follows: (i) the aberrations caused by high order fields of PMQs are relatively weak for low emittance measurement as long as the PMQs are properly constructed. A series of PMQs were manufactured and measured at Tsinghua University, and using numerical simulations their high order field effects were found to be negligible. (ii) The largest measurement error of emittance is caused by the angular misalignment between PMQs. For low emittance measurement of similar to 100MeV beams, an angular alignment accuracy of 0.1 degrees is necessary. This requirement can be eased for beams with higher energies. (iii) The transverse position misalignment of PMQs and angular fluctuation of incoming beams only cause a translational and rotational shift of measured signals, respectively, therefore, there is no effect on the measured value of emittance. (iv) The spatial resolution and efficiency of the detection system need to be properly designed to guarantee the accuracy of sub-100 nm rad emittance measurement.

Influence of Radial Magnetic Field on Emittance in the Median Plane at Cyciae-100

High Intensity Proton Beam Transportation Through Fringe Field of 70 MeV Compact Cyclotron to Beam Line Targets

The Design of Magnetic Field Measurements System for CYCIAE-100

Imperfection investigation for the main magnet construction for compact cyclotron *

Magnetic Field Measurement, Shimming and Processing for 230 MeV Superconducting Cyclotron Main Magnet

Radial Magnetic Field Optimization of the 5 T Superconducting Cyclotron for Medical Application

Magnet Design and Construction Preparation for CYCIAE-100 at CIAE

Investigation for the vertical focusing enhancement of compact cyclotron by asymmetrical shimming bar

Beam Transport Line of Ciae Medical Cyclotron and Its Magnetic Elements Design Studies

Isochronous Magnetic Field Shimming Method for Compact Cyclotrons

Investigation and quantitative simulation of beam physics for 230 MeV SC cyclotron under construction at CIAE

Magnet Design for a 70 MeV ${\rm H}^{-}/{\rm D}^{-}$ Dual Accelerating Particle Cyclotron

Numerical Investigation for High Intensity H− Beam Injection to a 100 MeV Compact Cyclotron

Magnet design for a 70 MeV H -/D - dual accelerating particle cyclotron

Magnet design optimization of a 100 MeV separated sector medical cyclotron and its injection line

Magnet Design and Engineering Technique Study on a 100mev Compact H-Cyclotron

On the Feasibility of Sub-100 Nm Rad Emittance Measurement in Plasma Accelerators Using Permanent Magnetic Quadrupoles

The Influence of Magnetic Field Configuration on an Electron Cyclotron Resonance Ion Source

Physics design on the axial injection system and the central region of the l00MeV high intensity cyclone

Development of Precise Magnetic Field Shimming Algorithm for Inclined 45° Continuous Cutting on Spiral Pole of SC Cyclotron

Measurement and adjustment of CIAE medical cyclotron magnet