Abstract:The mode of fuel management of the HTR-10 was studied, including the simulation of the fuel shuffling process and the measurement of the burnup, of a fuel element. The prior consideration was the design of the equilibrium state. Based on this the fuel loading of the initial core and the fuel shuffling mode from the initial core through the running-in phase into the equilibrium state were studied. The code system VSOP was used for the physical layout of the HTR-10 at the equilibrium state and in the running-in phase. For the equilibrium state, in order to lessen the difference between the peak and the average burnup, 5-fuel-passage-through-the-core was chosen for the fuel management. The average burnup of the spent fuel for the equilibrium core is 80 000 MWd t (-1), and the peak value of it is less than 100 000 MWd t (-1) when the burnup of the recycled fuel element is under 72 000 MWd t (-1). The mixture of fuel element and graphite element was used for the initial core loading, the volume fractions of the fuel and the graphite elements were 0.57 and 0.43, respectively. During the running-in phase, the volume fraction of graphite will decrease with the fresh fuel elements being loaded from the top of the core and the graphite elements discharged from the bottom of the core. The fuel shuffling mode is similar to that of the equilibrium state. The burnup limit of recycled fuel element is also 72 000 MWd t - 1 and the peak burnup is less than 100 000 MWd t (-1). Finally the core will be full of fuel elements with a certain profile of burnup and reaches the equilibrium state. According to the characteristics of the pebble-bed high temperature gas-cooled reactor, a calibrating method of concentration of (CS)-C-137 was proposed for the measurement of fuel burnup. (C) 2002 Elsevier Science B.V. All rights reserved.

Manufacture and Characteristics of Spherical Fuel Elements for the Htr-10

Fabrication Technology of Spherical Fuel Element for HTR-10

Design and Manufacture of the Fuel Element for the 10 MW High Temperature Gas-Cooled Reactor

Fabrication of Spherical Fuel Element for 10 MW High Temperature Gas-cooled Reactor

Research and Development of Fuel Element for Chinese 10 MW High Temperature Gas-cooled Reactor.

Irradiation Testing of Matrix Material for Spherical HTR-10 Fuel Elements

Preparation of Spherical Fuel Elements for Htr-Pm in Inet

Research and Development on the First-loading Coated Fuel Particles for the 10 MW High Temperature Gas-cooled Reactor

Fuel Irradiation of the First Batches Produced for the Chinese HTR-10

Research and Manufacture of Spherical Fuel Element for HTR-PM Demonstration Project

Preparation of Uo2 Kernel for Htr-10 Fuel Element

Fuel Management of HTR-10

A Comprehensive Study of the 14C Source Term in the 10 MW High-Temperature Gas-Cooled Reactor

Development of spherical fuel element detector

Program of Fuel Element in HTR-10

Irradiation Performance and Modeling of Htr-10 Coated Fuel Particles

Research on Manufacture Technology of Spherical Fuel Elements by Dry-Bag Isostatic Pressing

Gas Transportation of Fuel Element in HTR-10

Source Term Analysis and Sorting Scheme in Post-Irradiation Spherical Pyrometric Elements

Structural Design of Ceramic Internals of Htr-10

Fuel Management of the HTR-10 Including the Equilibrium State and the Running-in Phase