Abstract:The effect of the thermal treatment and composition on microstructure and subsequent mechanical behavior of an Al-2.6 wt.% Li-0.09 wt.% Zr alloy that was solution heat treated (SHT) and artificially aged for a series of aging times and temperatures was studied. The underaged, peakaged, and overaged thermal heat treatments were studied to determine the effect of the microstructure and processing on the mechanical properties. The precipitates in the microstructure, which impede dislocation motion and control the precipitation strengthening response as a function of aging practice, were analyzed as the basis for controlling the strengthening depending on their size distribution, average size, and interparticle spacing. The average particle size, spacing, and size distribution were determined from the microstructure as a function of the thermal processing and composition. For the demonstration alloy, the primary strengthening was a direct consequence of ordered coherent Al3Li (δ′) intermetallic precipitates, which are uniformly distributed throughout the microstructure and restrict the glide motion of dislocations during plastic deformation. The Al3Li average particle size, distribution, spacing, and volume fraction are closely related to the overall mechanical behavior and are a result of the heat treating practice and composition. Consequently, a micromechanical model was developed for predicting the precipitation hardening response in terms of the variation in polycrystalline strength with aging time, aging temperature, and composition. The overall micromechanical model, which was determined from the particle coarsening kinetics, dislocation mechanics, thermodynamics, resolved shear stress, as well as the dislocation particle shearing and bypassing mechanisms, accurately predicted the mechanical strength in the underaged, peak-aged, and overaged tempers of the demonstration alloy.

A study 0f serrated plastic flow behavior in an aluminum-lithium binary alloy

Serrated Flow Behavior in 2090 Al–Li Alloy Influenced by Texture and Microstructure

Influence of Precipitates on the Serrated Yielding in Al-Cu-Mg Alloy and Microscopic Experiment Investigation

Experimental Study and Mechanism Analysis of the Serrated Plastic Instability of Alloy Materials

Temporal Statistical Analysis of Serrated Yielding in Al-Cu Polycrystals

Insight into the aging behavior of a novel Al-Li-Cu-Mg alloy

Serrated Flow Behavior in 2090 Al-Li Alloy

The Influence of Aging Precipitates on the Mechanical Properties of Al–Li Alloys and Microstructural Analysis

Superplastic Behavior of an Al–Mg–Li Alloy

On the Origin of Deformation Mechanisms in a Heterostructured Aluminum Alloy Via Slip Trace and Lattice Rotation Analyses

Serrated Flow and Abnormal Strain Rate Sensitivity of a Magnesium–lithium Alloy

Anisotropy in creep-aging behavior of Al–Li alloy under different stress levels: experimental and constitutive modeling

The effect of temperature on the serrated flow in AA5456 alloys

Effect of Microstructure on High Cycle Fatigue Behavior of Al-Li Binary Alloy

Deformation and fracture behavior of a RSP Al–Li alloy

Characterization and constitutive analysis-based crystal plasticity of warm flow and fracture behaviours of 2060 Al-Cu-Li alloy

Microstructures, hot tensile deformation behavior and constitutive modeling in a superlight Mg-2.76Li-3Al-2.6Zn-0.39Y alloy

The Effect of Texture on the Serrated Flow in Peak-Aged 2090 Al-Li Alloy

Determining the Effect of Microstructure and Heat Treatment on the Mechanical Strengthening Behavior of an Aluminum Alloy Containing Lithium Precipitation Hardened with the δ′ Al3Li Intermetallic Phase

Statistical analysis of serrated flows in CoNiV medium-entropy alloy

Microstructural evolution and mechanical properties of the rapidly-solidified and hot-extruded 2196 Al-Li alloy