Abstract:Polyethersulfone (PES) hollow fiber ultrafiltration (UF) membranes were fabricated using methanol, ethanol, n-propanol as well as water as additives and N-methyl-2-pyrrolidone (NMP) as a solvent. Asymmetric hollow fiber UF membranes were spun by wet and dry/wet phase inversion method from 18wt.% solids of PES/non-solvent/NMP solutions. The non-solvents were methanol, ethanol, n-propanol and water while the external coagulant was water. Effects of non-solvent and ethanol concentrations in the dope solution and air-gap distance on morphology and separation performance of PES hollow fiber UF membranes were investigated. UF membranes were characterized in terms of their solubility parameter difference, pore size and pore density measurements, scanning electron microscope (SEM) while UF experiments were conducted using polyethylene glycol (PEG 10,000 MW) and two kinds of proteins, lysozyme (14,400 MW) and chicken egg albumin (CEA 45,000 MW) as a solute. It was found that the PES UF membrane morphology changed slowly from long and wide finger-like structure through a thin finger-like structure to the sponge-like structure with some voids as ethanol concentration in the dope solution increased from 0 to 25wt.% using 90:10 NMP/H2O as a bore fluid; pure water permeation fluxes (PWP) increased from 47 to 167L/(m2·h·bar) while rejections of PEG 10,000 and two protein for wet-spun PES hollow fiber membranes were increased within less than 10wt.% ethanol concentration and then decreased with an increase of ethanol concentration. Experimental results illustrated that PWP flux and solute rejection of the dry/wet-spun fibers were higher than that of the wet-spun fibers when 15wt.% ethanol and 15wt.% methanol were used as additives. PWP flux of PES hollow fibers using 25wt.% n-propanol and 7.5wt.% water (dry/wet) as additives in the dope solution were higher while their rejections were lower. In addition, the pore sizes of internal surfaces of PES hollow fiber membranes were controlled by adjusting the ethanol or methanol concentration in the dope solution. Using above method, PES hollow fiber UF membrane with high PWP could be prepared while the molecular weight cut-off of PES hollow fiber membranes is approximately 10,000.

Ultrafiltration Membrane Formation of Pes-C, Pes and Ppesk Polymers with Different Solvents

Preparation and Performance of Polyethersulfone Hollow-Fiber Membrane

PREPARATION OF POLY(PHTHALAZINONE ETHER SULFONE) ULTRAFILTRATION MEMBRANE

Preparation of PES ultrafiltration membrane for treatment of emulsified oily wastewater: Effect of solvent and non-solvent on morphology and performance

Effect of Different Solvents, Pore-Forming Agent and Solubility Parameter Differences on the Properties of PES Ultrafiltration Membrane

Effects of Operation Conditions, Solvent and Gelation Bath on Morphology and Performance of Ppesk Asymmetric Ultrafiltration Membrane

Preparation of poly(phthalazinone ether sulfone ketone)s ultrafiltration membrane

Preparation and Characterazition of Poly(Phthalazinone Ether Sulfone Ketone) Hollow Fiber Ultrafiltration Membrane with High-Molecular Weight Cut-Off

Preparation of poly(phthalazinone-ether-sulfone) sponge-like ultrafiltration membrane.

Performance Control of Asymmetric Poly(phthalazinone Ether Sulfone Ketone) Ultrafiltration Membrane Using Gelation

Effect of Polyethersulfone Molecular Weight on Structure and Performance of Ultrafiltration Membranes

Preparation and Characterization of Polyethersulfone Microporous Membrane Via Thermally Induced Phase Separation with Low Critical Solution Temperature System

Study on the Structure and Performance of Novel Poly(phthalazinone Ether Amide) Ultrafiltration Membrane

Preparation and Permeation Performances of Phenolphthalein Polyethersulphone Cardo（PES-C） Ultrafiltration Membranes

Preparation and Characterization of Novel Polyether Sulphone Ultrafiltration Membranes

Microporous Polyethersulfone Membranes Prepared under the Combined Precipitation Conditions with Non-Solvent Additives

Fabrication of high-flux asymmetric polyethersulfone (PES) ultrafiltration membranes via Nonsolvent-Induced phase separation: impact of coagulation bath temperature

Polymer Concentration and Solvent Variation Correlation with the Morphology and Water Filtration Analysis of Polyether Sulfone Microfiltration Membrane

Polyethersulfone (PES) hollow fiber ultrafiltration membranes prepared by PES/non-solvent/NMP solution

Poly(phthalazinone Ether Sulfone Ketone) (PPESK) Hollow Fiber Asymmetric Nanofiltration Membranes: Preparation, Morphologies and Properties

Preparation Of Micro-Porous Polyethersulphone Hollow Fibre Membranes Using Non-Solvent Vapour-Induced Phase Separation