Abstract:Transition metal oxides, which have a perovskite structure, have received much attention in recent decades. This is because of the very suitable properties that can be used in various industries. One of the fields where the properties of Perovskites can and have already been applied is in the power industry. Experimental studies of the last few years have reliably demonstrated that, using simple modifications, perovskite oxides can be used in applications utilizing direct sunlight and photocatalytic applications. The original strontium titanate oxide SrTiO3 (abbreviated STO) is only able to use the UV component of incident radiation and is inactive in visible light, remaining transparent to visible light. The reason for this state is its wide band gap, which at room temperature has a value of 3.2 - 3.25 eV. Studies have shown that doping the structure of these oxides with transition metals (TM) can cause a shift in the valence and/or conduction band. This is because of the 3d dopant bands that create new energy levels in the mentioned band gap, effectively reducing it. One of the elements of the TM group is nickel. According to some studies, it is likely that the Ni ion occurs in the cubic structure of STO in the form of Ni2+ and substitutes the Ti4+ sites. In the case of using this dopant, the shift of the absorption edge of STO:Nix relative to NiO was found to be 1.1 eV. The present work investigates the differences in the structure of STO:Nix prepared by magnetron deposition method with different dopant amount settings. At the same time, the difference in structure was observed when prepared under vacuum with Ar working gas and when O2 was flowed through the deposition chamber. The premise of this experiment was to verify the formation of oxygen vacancies in the STO structure on which the photocatalytic phenomenon could occur.

Photoluminescence of Nitrogen Doped SrTiO3

Optical Properties and Microstructure of Nitrogen-Doped SrTiO3

Defect-induced photoluminescence of strontium titanate and its modulation by electrostatic gating

Crystallite size and microstrain in the structure of SrTiO3 formed by magnetron deposition with and without O2 flow through the deposition chambre

Magnetic Properties of Nitrogen Doped SrTiO3

Structure and Properties of Nitrogen-Doped Titanium Dioxide Thin Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Time-resolved photoluminescence of n-doped SrTiO_3

Microstructures and Properties of N-Doped TiO_2 Films Grown by Dielectric Barrier Discharge Chemical Vapor Deposition

Effect of oxygen-ion implantation on the local electronic structures of strontium-titanate single crystals: An investigation using synchrotron-based x-ray diffraction and x-ray photoemission techniques

Structures and Optical Properties of Indium Doped SrTiO 3 Thin Films by Oxygen Plasma-Assisted Pulsed Laser Deposition

Microstructures and Properties of N-Doped TiO_2 Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Photo-oxidation properties of nitrogen doped SrTiO3 made by mechanical activation

Preparation and characterization of nitrogen doped SrTiO3 photocatalyst

Epitaxial growth of SrTiO3 films with different orientations on TiN buffered Si(001) by pulsed laser deposition

Characterization and evaluation of fibrous SrTiO3 prepared by hydrothermal process for the destruction of NO

Blue luminescence of SrTiO3 under intense optical excitation

Effects Of Nitrogen Incorporation On The Electronic Structure Of Rutile-Tio2

Visible Light Induced Electron Transfer Process over Nitrogen Doped TiO(2) Nanocrystals Prepared by Oxidation of Titanium Nitride.

Scanning tunnelling microscopy and X-ray photoemission studies of NdNiO2 infinite-layer nickelates films

The photoluminescence and magnetism of nitrogen-implanted ZnO

Photoelectrochemical and Optical Properties of N-doped TiO2 Thin Films Prepared by Oxidation of Sputtered TiNx Films