Abstract:Fabrication and organosilane-functionalization and characterization of nanostructured ITO electrodes are reported. Nanostructured ITO electrodes were obtained by electron beam evaporation, and a subsequent annealing treatment was selectively performed to modify their crystalline state. An increase in geometrical surface area in comparison with thin-film electrodes area was observed by atomic force microscopy, implying higher electroactive surface area for nanostructured ITO electrodes and thus higher detection levels. To investigate the increase in detectability, chemical organosilane-functionalization of nanostructured ITO electrodes was performed. The formation of 3-glycidoxypropyltrimethoxysilane (GOPTS) layers was detected by X-ray photoelectron spectroscopy. As an indirect method to confirm the presence of organosilane molecules on the ITO substrates, cyclic voltammetry and electrochemical impedance spectroscopy (EIS) were also carried out. Cyclic voltammograms of functionalized ITO electrodes presented lower reduction-oxidation peak currents compared with non-functionalized ITO electrodes. These results demonstrate the presence of the epoxysilane coating on the ITO surface. EIS showed that organosilane-functionalized electrodes present higher polarization resistance, acting as an electronic barrier for the electron transfer between the conductive solution and the ITO electrode. The results of these electrochemical measurements, together with the significant difference in the X-ray spectra between bare ITO and organosilane-functionalized ITO substrates, may point to a new exploitable oxide-based nanostructured material for biosensing applications. As a first step towards sensing, rapid functionalization of such substrates and their application to electrochemical analysis is tested in this work. Interestingly, oxide-based materials are highly integrable with the silicon chip technology, which would permit the easy adaptation of such sensors into lab-on-a-chip configurations, providing benefits such as reduced size and weight to facilitate on-chip integration, and leading to low-cost mass production of microanalysis systems.

Preparation of a Porous ITO Electrode

Gas Phase Fabrication of Morphology-Controlled ITO Nanoparticles and Their Assembled Conductive Films.

Dye-Sensitized Nanostructured Crystalline Mesoporous Tin-doped Indium Oxide Films with Tunable Thickness for Photoelectrochemical Applications

Preparation and photoelectrochemical properties of porous thin films composed of submicron TiO2 particles

Preparation and characterization of hollow spherical indium tin oxide with micro size by template assisted hydrothermal method

Preparation of porous ITO glasses with tunable pores and enhanced H2O2

Shape-Controlled Synthesis of Porous Screw-Cap-Like Indium Tin Oxide and Its Application for Gas Sensing

Light-triggered Ph/thermal Multisensitive Polyelectrolyte/ito Glass Hybrid Electrode

Preparation, characterization, and photoelectric properties of poly(1,3,5-tri(thiophene-2-yl)benzene) film electrodes

Preparation and Electrical Properties of Electrospun Tin-Doped Indium Oxide Nanowires

Preparation of TiO 2 /ITO film electrode by AP-MOCVD for photoelectrocatalytic application

Optimization Preparation of Indium Tin Oxide Nanoparticles via Microemulsion Method Using Orthogonal Experiment

Preparation and photovoltaic properties of the composite based on porous In2S3 films and PCPDTBT

Efficient low-cost and facile ITO interdigital micro-photodetector based on mixed cationic perovskite for screening new optoelectronic materials

Transparent electrodes for organic optoelectronic devices: a review

Preparation and photovoltaic properties of the composite based on porous In 2 S 3 films and PCPDTBT

Large-Scale, High-Transparency, Ultra-thin ITO Membranes with Robust Conductivity and Flexibility

Organosilane-functionalization of nanostructured indium tin oxide films

Electro-Chemical Preparation of Tio2/Cnt Electrodes with Tnb Electrolyte and Their Photoelectrocatalytic Effect

Transparent Indium Tin Oxide Electrodes on Muscovite Mica for High-Temperature-Processed Flexible Optoelectronic Devices

Polymer Photovoltaic Cell UsingTiO2/G-PEDOT Nanocomplex Film As Electrode