Abstract:The preparation of pellets using a high-shear granulator in a rapid single-step is considered a good economic alternative to the extrusion spheronization process. As process parameters and material attributes greatly affect pellet qualities, successful process optimization plays a vital role in producing pellet dosage forms with the required critical quality attributes. This study was aimed at the development and optimization of the pelletization technique with the Pro-CepT granulator. According to the quality by design (QbD) and screening design results, chopper speed, the volume of the granulating liquid, binder amount, and impeller speed were selected as the highest risk variables for a two-level full factorial design and central composite design, which were applied to the formula of microcrystalline cellulose, mannitol, and with a binding aqueous polyvinylpyrrolidone solution. The design space was estimated based on physical response results, including the total yield of the required size, hardness, and aspect ratio. The optimized point was tested with two different types of active ingredients. Amlodipine and hydrochlorothiazide were selected as model drugs and were loaded into an optimized formulation. The kinetics of the release of the active agent was examined and found that the results show a correlation with the electrokinetic potential because amlodipine besylate can be adsorbed on the surface of the MCC, while hydrochlorothiazide less so; therefore, in this case, the release of the active agent increases. The research results revealed no significant differences between plain and model drug pellets, except for hydrochlorothiazide yield percent, in addition to acceptable content uniformity and dissolution enhancement.

Technique of Centrifugal Granulation for Preparation of Pellets and Factors Influencing the Quality

Influence of the centrifugal granulating process on the properties of layered pellets

Granulation techniques and technologies: recent progresses

Centrifugal granulation behavior in metallic powder fabrication by plasma rotating electrode process

Application of Near-Infrared Spectroscopy Combined with Design of Experiments for Process Development of the Pulsed Spray Fluid Bed Granulation Process

Application of Definitive Screening Design to Quantify the Effects of Process Parameters on Key Granule Characteristics and Optimize Operating Parameters in Pulsed-Spray Fluid-Bed Granulation

Powder agglomeration processes of bulk materials – A state of the art review on different granulation methods and applications

Granulation performance by hybrid centrifugal-air blast technique for treatment of liquid slag

Investigation of mixing homogeneity of binary particle systems in high-shear wet granulator by DEM

Nucleation, growth and breakage phenomena in agitated wet granulation processes: a review

Development of tapered rotating fluidized bed granulator for increasing yield of granules

Investigation of the Electrokinetic Potential of Granules and Optimization of the Pelletization Method Using the Quality by Design Approach

Review of the Principles, Devices, Parameters, and Applications for Centrifugal Electrospinning

An Understanding of the Relationship Between Mixing Performance and Power Consumption in a High-Shear Wet Granulation Pre-mixing

A critical review on granulation of pharmaceuticals and excipients: Principle, analysis and typical applications

Investigating the Effects of Mixing Dynamics on Twin-Screw Granule Quality Attributes via the Development of a Physics-Based Process Map

Study on Preparation Technology and Physical Fingerprint of Chuilian Jianpi Granules Based on QbD

An Evaluation of Process Variables in wet Granulation

Process Simulation of Twin-Screw Granulation: A Review

Optimization of preparation technique for the Qiyuejiangzhi tablets

Preparation of ZrO2 microspheres by spray granulation