Abstract:This paper reports turbulent boundary layer measurements made over open-cell reticulated foams with varying pore size and thickness, but constant porosity ($\epsilon \approx 0.97$). The foams were flush-mounted into a cutout on a flat plate. A Laser Doppler Velocimeter (LDV) was used to measure mean streamwise velocity and turbulence intensity immediately upstream of the porous section, and at multiple measurement stations along the porous substrate. The friction Reynolds number upstream of the porous section was $Re_\tau \approx 1690$. For all but the thickest foam tested, the internal boundary layer was fully developed by $<10 \delta$ downstream from the porous transition, where $\delta$ is the boundary layer thickness. Fully developed mean velocity profiles showed the presence of a substantial slip velocity at the porous interface ($>30\%$ of the free stream velocity) and a mean velocity deficit relative to the canonical smooth-wall profile further from the wall. While the magnitude of the mean velocity deficit increased with average pore size, the slip velocity remained approximately constant. Fits to the mean velocity profile suggest that the logarithmic region is shifted relative to a smooth wall, and that this shift increases with pore size until it becomes comparable to substrate thickness $h$. For all foams, the turbulence intensity was found to be elevated further into the boundary layer to $y/ \delta \approx 0.2$. An outer peak in intensity was also evident for the largest pore sizes. Velocity spectra indicate that this outer peak is associated with large-scale structures resembling Kelvin-Helmholtz vortices that have streamwise length scale $2\delta-4\delta$. Skewness profiles suggest that these large-scale structures may have an amplitude-modulating effect on the interfacial turbulence.

Measurement of tortuosity in aluminum foams using airborne ultrasound

Measurements Of Ultrasonic Phase Velocities And Attenuation Of Slow Waves In Cellular Aluminum Foams As Cancellous Bone-Mimicking Phantoms

Frequency Spectral Analysis for the Ultrasonic Attenuation of Carbon Fiber Reinforced Plastics

Topological Characteristics and Mechanical Properties of Uniaxially Thermoformed Auxetic Foam

Characterization of rigid open-cell foams using direct ultrasonic simulation

Ultrasonic measurements of the bulk flow field in foams

Sound Absorption and Transmission Loss Properties of Open-Celled Aluminum Foams with Stepwise Relative Density Gradients

A technique for measuring velocity and attenuation of ultrasound in liquid foams

Study on Cell Deformation of Low Porosity Aluminum Foams under Quasi‐Static Compression by X‐Ray Tomography

RESEARCH ON THE INTERNAL FRICTION OF FOAMED ALUMINIUM IN ACOUSTIC FREQUENCY

Investigation of ultrasound velocity measurements of polymeric parts with different surface roughness

Study on Damping Behavior of Foamed Aluminum with Macroscopic Pores

In-Situ Thickness Measurement of Porous Alumina by Atomic Force Microscopy and the Reflectance Wavelength Measurement from 400-1000 Nm

Three-dimensional Voronoi-based simulation study of stepwise density-graded aluminum foams: Buffering and energy absorption performance analysis

Mean turbulence statistics in boundary layers over high-porosity foams

Ultrasonic Evaluation of Acoustoelastic Parameters in Aluminum

Assessment of the flow behavior and structural performance of open-cell aluminum foams at critical flow conditions of pressure and temperature

Mechanical Simulation of the Localized Deformation in the Aluminum Foams: A Three-Dimensional (3d) Structure Based Study

Micro-CT in the mechanical properties and energy absorption of closed-cell aluminium foam

High temperature and mesostructure effect on aluminum foam compression responses

Numerical Simulation of Aluminum Foams by Space Holder Infiltration