Abstract:Removal of NOx from lean diesel exhaust can be achieved by the use of selective catalytic reduction technology. The supplied reductant is often ammonia, either as urea or as ammonia gas released from a storage medium. Experiments have been carried out on an engine test rig run to steady state conditions using NOx composed mainly of NO, with ammonia gas as the reductant. This was essentially a 1D study because a long 10 degree diffuser was used to provide uniform temperature and velocity profile to the SCR catalyst brick in the test exhaust system. Tuning of the standard reaction, the NO SCR reaction, in a kinetic scheme from the literature and adjustment of the ammonia adsorption kinetics achieved improved agreement between the measurements and CFD simulations. This was carried out for studies at exhaust gas temperatures between 200 and 300°C. The effect of diffuser geometry upstream of the SCR catalyst on NOx conversion was then investigated experimentally using a 180 degree sudden expansion as a 3D diffuser. These were also steady state studies with the exhaust NOx composed mostly of NO. The SCR brick was short, 45 mm in length, to provide a rigorous test of the kinetics. Observed NOx conversion profiles for ammonia supplied in quantities ranging from deficient to excess showed that the combined influence of temperature and velocity profiles upstream of the SCR was apparent in this 3D case. 2D axially symmetric CFD simulations have been carried out to model the 3D case and the predictions are discussed and compared with engine test data in this paper.

Experimental Study and Simulation of SNCR (selective Non-Catalytic Reduction) Denitrification Process with Gas-state Ammonia Serving As a Reducing Agent

Experimental and Modeling Study on the Mechanism and Sensitive Parameters of the Thermal DeNOx Process

Experimental Study and Mechanism Analysis on Selective Non-Catalytic Reduction Reactions

Experimental Investigations of Enhanced Selective Non-catalytic Reduction Reaction with Methane

Calculation and Analysis of Denitration Technology with Hydrocarbons and Ammonia Serving As a Reducing Agent

Experimental Study on NOx Reduction by Nitrogen Agents and Pyrolysis Characteristic of Nitrogen Agents

Experimental Study of the Enhancement of the Selective Noncatalytic Reduction Denitrification Process with Methane and Propane in a Circulating Fluidized Bed

Application of Selective Non-catalytic Reduction Denitrification

Numerical Investigation on Promoting Selective Non-catalytic Reduction with Methane Additive by Computational Fluid Dynamics

MODELING AND EXPERIMENTAL STUDY ON NO_x REDUCTION IN FURNACE WITH AMMONIA INJECTION

Simulation and Optimization of SNCR Process

Experimental and Modeling Study on the Influence of H2 Addition on Selective Non-catalytic Reduction Process

An experimental and modelling study of the Selective Non-Catalytic Reduction (SNCR) of NOx and NH3 in a cyclone reactor

Numerical Study of SNCR Process in Coal-Fired Boiler with Large Capacity

Tuning the Standard SCR Reaction Kinetics to Model NO Conversion in a Diesel Engine Exhaust SCR Catalyst System Under Steady State Conditions in 1D and 3D Geometries Using Ammonia Gas as the Reductant

Analysis of ammonia combustion for decarbonization followed by selective non-catalytic reduction of nitrogen oxides

Effect of Methane and Temperature on NO Removal Using by the Selective Non-Catalytic Reduction

Mechanism Validation and Analysis of the Selective Non-catalytic Reduction Reaction with Methane Additive

SELECTIVE REDUCTION DENITRIFICATION OF FLUE GAS BY USING CATALYST Ag/Al2O3 AND REDUCING AGENT C3H6

Influence of Calcium-Based Particles on the Selective Non-Catalytic Reduction Process in a Pre-Calciner

CFD-based investigation of NO x removal from industrial waste gas by selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR) process using NH 3