Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. A simplified tire finite element model modeling and simulation method with high efficiency and accuracy is proposed to address the issues of poor efficiency and low accuracy in tire finite element simulation. Firstly, the detailed finite element model of the tire is established, and the viscoelastic material parameters are determined through theoretical analysis and simulation verification. Then, the Hyperelastic material parameters are obtained through cyclic Tensile testing, and finally, the static tire condition test verification is completed. Based on the established detailed finite element model of the tire, the influence of different rubber materials on the dynamic characteristics of the tire is studied. On this basis, simplified friction and structure models are proposed to complete the establishment of a simplified tire finite element model. The simulation results of lateral and longitudinal slip conditions are compared with experimental data by implanting a finite element friction model that considers slip velocity and contact pressure. Through simulation analysis, it was found that the tread compound has a significant impact on the dynamic characteristics of the tire, while other compounds have a relatively small impact. Simplifying the tire finite element model can significantly improve the efficiency of finite element simulation and reduce convergence issues. The comparison accuracy between the finite element model simulation results and experimental data is relatively high, with the average accuracy of longitudinal force, lateral force, and correction moment reaching 89%, 95%, and 81%, respectively. This verifies the correctness and effectiveness of the simplified tire finite element model modeling and simulation method. This method provides certain reference significance for improving the efficiency of tire finite element simulation and providing virtual matching between tires and the entire vehicle.

Numeric Analysis of Friction Contact Between Tread and Flexible Pavement

Elastoplastic Analysis of Asphalt Concrete Pavement

Numberical Analysis on the Steady-State Rolling of Load-Carrying Tire

Finite Element Analysis For Tire Tread Wear Under Typical Loading Conditions

Research on simplified tire finite element modeling and simulation method

Numerical Simulation of Mechanical Response Analysis of Asphalt Pavement under Dynamic Loads with Non-Uniform Tire-Pavement Contact Stresses

FINITE ELEMENT ANALYSIS FOR SLIDING ABRASION OF TREAD BLOCKS OF RADIAL TIRE

Finite Element Method-Based Skid Resistance Simulation Using In-Situ 3D Pavement Surface Texture and Friction Data

An Implicit To Explicit Fea Solving Of Tire F&M With Detailed Tread Blocks

Investigation of surface textures deterioration on pavement skid-resistance using hysteresis friction models and numerical simulation method

Finite Element Analysis for Tread Wear of Radial Tire

Numerical Analysis on Deformation of Pavement and Soft Clay Ground Interaction for Cyclic Loads

3D FEM analysis of flexible base asphalt pavement structure under non-uniform tyre contact pressure

Tire-Pavement Interaction Simulation Based on Finite Element Model and Response Surface Methodology

Modeling and Validation of a Passenger Car Tire Using Finite Element Analysis

Hysteresis Friction Modelling of BPT Considering Rubber Penetration Depth into Road Surface

Rubber Friction on Icy Pavement: Experiments and Modeling

Tire cornering simulation using finite element analysis

Tire-Pavement Contact Pressure Distribution Analysis Based on ABAQUS Simulation

Deflection and Contact Characteristics of A Wide-Base Tyre on the Pavement

Experimental and Numerical Studies on Tire Tread Block Friction Characteristics Based on a New Test Device