Abstract:In recent years targeted radionuclide therapy has become a topic of great interest as a growing number of cancers can potentially be treated with radionuclides like lutetium-177 and samarium-153. To facilitate this growth and meet the demand, preparation and purification of lutetium-177 is increasing in importance. In the most common production route, enriched ytterbium-176 targets are irradiated and the produced lutetium-177 is separated from the ytterbium target material. This challenging separation is commonly performed using ion exchange resins, a method limited in scalability as the chemical similarity between ytterbium and lutetium results in poor separation at higher concentrations. An alternative method to aid the separation of lutetium from ytterbium is the electrochemical reduction of ytterbium as a change in oxidation states changes chemical properties significantly. Ytterbium has an accessible divalent state, whereas lutetium has not. However, the very negative value of the Yb(III)/Yb(II) standard reduction potential (E 0 = -1.04 V vs. SHE) does pose some challenges as it becomes a necessity to work in non-aqueous solvents with a very low water content. Similar research has already been performed in our group, looking into the separation of samarium-153 from europium-154, reducing europium in nitrate media, followed by a separation over TEVA resin. In this study, we investigated the reduction of ytterbium in ethylene glycol, dimethyl sulfoxide, tetrahydrofuran and N,N-dimethyl formamide by cyclic voltammetry, linear sweep voltammetry and electronic impedance spectroscopy. The influence of multiple variables such as moisture content on the reduction kinetics and stability of Yb(II) was determined and a Koutecky-Levich analysis was performed. Our results demonstrate that the reduction of ytterbium in non-aqueous solvents is feasible but attempts to perform bulk electrolysis were not successful yet. Ethylene glycol, dimethyl sulfoxide and N,N-dimethyl formamide demonstrate favorable conditions and in each solvents clear reduction and oxidation peaks were observed. It was found that the solvents do affect the peak separation, reduction potential and sensitivity to passivation. Figure 1

Purification of Ytterbium from Heavy Rare Earth Sulphate Solution by Electrolysis Reduction

Electroextraction of Ytterbium on the Liquid Lead Cathode in LiCl-KCl Eutectic

Electrochemical Reduction of Ytterbium in Non-Aqueous Solvents - Towards Production of Pure Medical Lutetium-177

Electrolytic Extraction of Yttrium Using Recycle Liquid Gallium Electrode from molten LiCl-KCl

Separation and purification of Yb2O3 by ion exchange chromatography and preparation of ultra-high purity Yb2O3

Purification of yttrium to 4N5+ purity

Separation of lanthanides erbium and ytterbium on indium electrodes by modulated potential selective extraction in molten salts and a thermodynamic and kinetic analysis of the process

Selective recovery of yttrium oxide and yttrium–europium oxide particles from fluorescent wastes by solvent extraction, precipitation, and calcination

Selective electro-oxidative separation of Sm, Yb, and Eu in low-temperature molten salt AlCl 3 -NaCl

Efficient removal of fission product thulium by electrolytic refining and high temperature adsorption of molecular sieves to achieve the purification and reuse of waste salt

An innovative technique for the separation of ion-adsorption high yttrium rare earth ore by Er (III) / Tm (III) grouping first

Investigation into cathodic reduction process of Yb(III) ion in (LiF-YbF3)eut.-Yb2O3 molten salt system

Thermodynamic Data of Separating Yttrium from Heavy Rare Earths via a Phenoxypropionate-Based Ionic Liquid

Electrolytic separation of Dy from Sm in molten LiCl-KCl using Pb-Bi eutectic alloy cathode

Preparation of High Purity Rare Earth Metals of Samarium, Ytterbium and Thulium

Solvent Extraction of Rare Earth Ions from Nitrate Media with New Extractant Di-(2,3-dimethylbutyl)-phosphinic Acid

Passivation Phenomenon and Variable Properties of Ytterbium in Different Lewis Acid AlCl 3 -NaCl Melts

Environmentally Friendly Strategy for Treating In Situ Leaching Solutions of Ion-Adsorption Type Yttrium-Rich Heavy Rare-Earth Ore by a Bubble-Supported Organic Liquid Membrane

Selective separation of Dy(III), Yb(III) and Y(III) by complexation and orderly decomplexation coupling with ultrafiltration based on rotating disk membrane and a DFT study

Research on the Removal of Impurity Elements During Ultra-High Purification Process of Terbium

Separation of adjacent heavy rare earth Lutetium (III) and Ytterbium (III) by task-specific ionic liquid Cyphos IL 104 embedded polymer inclusion membrane