Abstract:Trifluoroacetic acid-metal-organic deposition (TFA-MOD) is an effective method to prepare high-quality yttrium–barium–copper oxide (YBCO) superconducting thin films with a large area. Chemical reactions and purification are the keys to the preparation of the precursor solution in the TFA-MOD method. In this study, the process of preparing the precursor solution was examined by the infrared spectra systematically, and each infrared spectrum was determined by Fourier-transform-infrared spectroscopy (FTIR) to judge the possible side reactions. The results show that organic functional groups have no side effects at room temperature (20 ± 2°C). And the purification process can remove excess water, acid, and so on. The purity of the precursor solution would increase with distillation. When the relative height ratio of CF3− and the C−OH absorption peak in the spectra of solution 3, which has been purified three times, reaches 0.664, and the relative ratio of C−F and the C−OH absorption peak is 0.418, a YBCO thin film can be obtained with a perfectly uniform surface. Its transition-onset temperature is approximately 90.9 K, the value of critical current density (Jc) is 2.32 mA/cm2 (77 K, 0 T), and the growth of the superconducting film is strongly oriented to the c-axis. In addition, it was found that distillation removes excess water, acetic acid, and other small molecules, and determines the quality of YBCO thin films. For this performance, a superconducting film has been successfully applied to filter the fabrication. Therefore, this method is essentially an effective method to study the content of impurities in the precursor solution in order to form a superconducting film with good quality.The picture above is a summary of the article charts, divided into four major steps. In this study, the process of preparing the precursor solution was examined by infrared spectra systematically, and each infrared spectrum was determined by Fourier transform infrared spectroscopy (FTIR) to judge possible side reactions. And the microstructure and superconductivity of thin film have been characterized by XRD, SEM, CRYO SCAN equipment and four-probe method. Finally, this performance of superconducting film haves been successfully applied to the filter fabrication through this research method.

Separation and purification of Yb2O3 by ion exchange chromatography and preparation of ultra-high purity Yb2O3

Ion Exchange Resin Separation and Purification of Ε-Poly-l-lysine from the Fermentation Broth of Streptomyces Violaceusniger

Purification of Ytterbium from Heavy Rare Earth Sulphate Solution by Electrolysis Reduction

Research on the Removal of Impurity Elements During Ultra-High Purification Process of Terbium

An innovative technique for the separation of ion-adsorption high yttrium rare earth ore by Er (III) / Tm (III) grouping first

Purification of yttrium to 4N5+ purity

Study of precursor-solution purity for high-quality yttrium–barium–copper-oxide superconducting thin film

Application of annular centrifugal contactors in the extraction flowsheet for producing high purity yttrium

Selective recovery of yttrium oxide and yttrium–europium oxide particles from fluorescent wastes by solvent extraction, precipitation, and calcination

Thermodynamic Data of Separating Yttrium from Heavy Rare Earths via a Phenoxypropionate-Based Ionic Liquid

Separation and Recovery of Cr(Iii) and Cr(Vi) Using Electrodeionization As an Efficient Approach

Selective separation of Dy(III), Yb(III) and Y(III) by complexation and orderly decomplexation coupling with ultrafiltration based on rotating disk membrane and a DFT study

Crown Ether–ionic Liquid-Based Extraction Chromatographic Resin for Separation of 90 Y from 90 Sr

Recovery and Purification of Iridium from Secondary Resources: A Review

Separation behavior of trace impurities during deep purification of zone-fused germanium tailings via vacuum distillation

Separation of lanthanides erbium and ytterbium on indium electrodes by modulated potential selective extraction in molten salts and a thermodynamic and kinetic analysis of the process

Study of the Adsorption and Separation Behavior of Scandium and Zirconium by Trialkyl Phosphine Oxide-Modified Resins in Sulfuric and Hydrochloric Acid Media

An effective process for the separation of U(VI), Th(IV) from rare earth elements by using ionic liquid Cyphos IL 104

Desorption behavior and mechanism of yttrium ions from ion-adsorption type rare earths ore

Separation of europium as a homologue of americium from high acidity solutions using a manufactured resin material

Tailored ternary hydrophobic deep eutectic solvents for synergistic separation of yttrium and heavy rare earth elements