Abstract:The reasonable and rapid prediction of turbine performance based on design targets such as mass flow rate and pressure ratio is indispensable in the preliminary and conceptual design stage for gas turbine engines in the aviation and power generation industry. However, the lack of detailed geometrical and aerodynamic parameters in this stage significantly challenges the reasonable evaluation of turbine characteristics. The present work proposes a rapid prediction method of axial turbine performance by coupling the inverse design and direct analysis. Firstly, according to the one-dimensional mean line design theory with empirical loss and deviation correlation models, the basic aerodynamic and geometrical parameters are quickly obtained by solving the inverse problem to fulfill the design targets such as mass flow rate and pressure ratio with optimized efficiency. Then, by adopting the loss and deviation correlation models in the off-design conditions, the turbine characteristics in a wide range of operating conditions are obtained by solving the direct analysis problem. Thus, the reasonable and rapid prediction of the turbine characteristics can be realized by coupling the inverse design with direct analysis. Based on the built prediction model, the effect of various deviation models on the predicted turbine characteristics, which was not systematically investigated in previous studies, is clarified by comparing the predicted performance with published test results. Finally, an optimization method of the empirical coefficients in turbine loss and deviation models based on the Genetic Algorithm (GA) is introduced. This method employs optimization theory and existing experimental data to improve the prediction accuracy. The results show that the averaged prediction discrepancies of output powers and mass flow rates in a wide range of operating conditions are no more than 2% and 2.5% for test cases after the optimization of model coefficients. Therefore, this optimization method is expected to be used for updating the empirical coefficients to improve the model prediction accuracy, accompanying the evolution of turbine design strategy at present or in the future.

The Application of a Loss and Deviation Angle Model on Performance Prediction of Axial Flow Compressor

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

Effect and Mechanism of Roughness on the Performance of a Five-Stage Axial Flow Compressor

A throughflow-based optimization method for multi-stage axial compressor

Performance Impact of Uncertain Variations of Inlet Flow for Axial Compressor Blades

Numerical Prediction of Multi-Stage Axial Compressor Performances

An improved deviation model for transonic stages in axial compressors

Two-dimensional Performance Prediction Method of Axial Compressor for Stall Margin Customizing

Investigation on the Performance Prediction of Single-Stage Axial Compressor by Using Different Turbulence Models

Experiment and Numerical Simulation of the Performance on Scaled Compressor Cascade and Development of a Prediction Model

An axisymmetric characteristic model for enhancing the prediction of centrifugal compressor characteristics

Rapid Performance Prediction Model of Axial Turbine with Coupling One-Dimensional Inverse Design and Direct Analysis

Quantitative analysis of energy loss and performance prediction of regenerative compressor

Calculation of the Overall Aerodynamic Performance of Multi-Stage Axial-Flow Compressor

Bleed air CFD modelling in aerodynamic simulation of A heavy duty gas turbine compressor

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

Development of A Throughflow Method for Aerodynamic Analysis of Highly Loaded Axial Flow Compressors

Several Key Points for Improving Performance Numerical Prediction of Low-pressure Axial Flow Compressor

An 11-Stage Axial Compressor Performance Simulation Considering the Change of Tip Clearance in Different Operating Conditions