Abstract:The assembly precision of high pressure compressor (HPC) multi-stage rotors is critical to the healthy and high-performance operation of aeroengine. The traditional trial assembly method usually requires multiple disassembly and assembly of rotors to ensure assembly precision, which is cumbersome and may cause damage to parts. It is important to predict and optimize the stacking precision of multi-stage rotors to improve the assembly quality and reduce aeroengine operational failure. This paper proposes a novel method for stacking optimization of aeroengine multistage rotors based on 3D deviation prediction model. First, the three-dimensional deviation propagation and accumulation process in the stacking process of a fourstage rotor is deduced using the coordinate transformation method, and the 3D deviation prediction model is established to derive the concentricity and perpendicularity of rotors under different bolt hole phase combinations; Second, the Gaussian distribution is used to simulate the radial and axial runout data of the upper end surface of each stage of rotor, and the center and unit normal vector of the upper end surface of rotors are obtained by the least squares method, then the predicted values of concentricity and perpendicularity of rotors under different bolt hole phase combinations are calculated through the 3D deviation prediction model; Third, a dual-objective integer optimization function is established, and the optimal installation phase and the corresponding predicted values of concentricity and perpendicularity of rotors are obtained. The proposed method can predict the concentricity and perpendicularity of rotors and optimize the stacking phase accurately, so as to achieve the target stacking precision requirements through a single assembly, which can provide theoretical guidance for the actual stacking process of aeroengine multi-stage rotors.

Two-dimensional Performance Prediction Method of Axial Compressor for Stall Margin Customizing

A Novel Method for Stacking Optimization of Aeroengine Multi-stage Rotors Based on 3D Deviation Prediction Model

A throughflow-based optimization method for multi-stage axial compressor

Quantification Of Performance Uncertainty For A Transonic Compressor Rotor Using An Adaptive Nipc Method

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Performance Sensitivity Analysis and Aerodynamic Optimization of Compressor Cascades by a Turbulence Adjoint Method

A Method of Stall and Surge Prediction in Axial Compressors Based on Three-Dimensional Body-Force Model

An Improved Prediction Model for Corner Stall in Axial Compressors with Dihedral Effect

Investigation on the Performance Prediction of Single-Stage Axial Compressor by Using Different Turbulence Models

Numerical Prediction of Multi-Stage Axial Compressor Performances

A Combined Method of CFD Simulation and Modified Beddoes-Leishman Model to Predict the Dynamic Stall Characterizations of S809 Airfoil

Multi-objective Optimization Design of Axial Compressor Blade and Stability Margin Analysis

Analytic Method for Computing Axial-flow Compressor and Turbine Characteristics

Investigation on corner stall prediction and flow control by blended blade and endwall technology in a compressor cascade based on modified Spalart-Allmaras model

Calculation of the Overall Aerodynamic Performance of Multi-Stage Axial-Flow Compressor

Investigation on corner stall prediction and flow control by blended blade and end wall technology in a compressor cascade based on modified Spalart-Allmaras model

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor

Investigation of non-uniform leading-edge tubercles in compressor cascade: Based on multi-objective optimization and data mining

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor

Modeling and Detection of Rotating Stall in Axial Flow Compressors:Part I - Investigation on High-order M-G Models Via Deterministic Learning