Abstract:Isostructural alloying has been regarded as an important approach to boosting thermoelectric performance of narrow gap semiconductors through thermal conductivity reduction. However, it does harm to carrier mobilities as well because of atomic disorders. Here, we extend the alloying concept from "isostructural" to "quasi-isostructural", which means that the two alloying components are no longer strictly isostructural but structurally closely related. As a proof-of-concept, a series of cubic Cu2SnSe3–tetragonal Cu3SbSe4 quasi-isostructural alloys (Cu2+xSn1–xSbxSe3+x) were synthesized, and their thermoelectric transport properties were systematically studied. No significant loss of carrier mobilities was found during quasi-isostructural alloying, probably due to the structural similarity of the two end members as well as the negligible mass contrasts between Sn and Sb. Surprisingly, a remarkable reduction of lattice thermal conductivity from 1.2 W m–1 K–1 for Cu2SnSe3/Cu3SbSe4 to 0.4 W m–1 K–1 for Cu5SnSbSe7 at 673 K was observed, which can hardly be explained from a solid solution perspective. Our X-ray photoelectron spectroscopy analysis unambiguously demonstrate the coexistence of Sn2+ and Sn4+ in the alloying systems, whereas Sn simply exhibits Sn4+ in Cu2SnSe3. We deduce that the minute structural changes of Cu2SnSe3 during quasi-isostructural alloying make Sn discordant, leading to its valence state splitting. The mixed-valence scattering therefore strongly impedes phonon propagation beyond alloying. Altogether, a considerably enhanced ZT ≈ 0.4 is realized in the sample with x = 0.2, which is 150% improvement over the x = 0 sample. By selecting the x = 0.5 sample as a representative, a preliminary doping study was performed but seems unsuccessful because of the varying Sn2+/Sn4+ ratio. We expect higher thermoelectric performance in those quasi-isostructural alloys if their carrier concentration can be fully optimized.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.1c01155?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.1c01155</a>.Temperature-dependent heat capacity (Cp), thermal diffusivities (D) and Lorenz number (L) for Cu2+xSn1–xSbxSe3+x (x = 0, 0.2, 0.5, 0.8, and 1.0). The longitudinal (νl) and transverse (νt) acoustic velocities, calculation of average acoustic velocity (vs) (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.1c01155/suppl_file/ae1c01155_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Thermoelectric properties of Cu-added Zn–Sb based alloys with multi-phase equilibrium

Enhanced Thermoelectric Properties Of Cu3sbse3-Based Composites With Inclusion Phases

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Realizing the Ultralow Lattice Thermal Conductivity of Cu3SbSe4 Compound via Sulfur Alloying Effect

High Thermoelectric Figure of Merit Achieved in Cu2S1-xTex Alloys Synthesized by Mechanical Alloying and Spark Plasma Sintering

Enhancing thermoelectric performance of Cu1.8S by Sb/Sn co-doping and incorporating multiscale defects to scatter heat-carrying phonons

Synergistically enhanced thermoelectric properties of Bi2S3 bulk materials via Cu interstitial doping and BiCl3 alloying

Enhanced thermoelectric properties of Cu1.8S via the introduction of ZnS nanostructures

High Thermoelectric Performance in Cu2SnS3 by Control Over Phase‐Dependent Mobility Edge

Excellent thermoelectric properties and stability realized in copper sulfides based composites via complex nanostructuring

Study the effect of alloying on the phase transition behavior and thermoelectric properties of Ag2S

Quasi-isostructural Alloying of Cu 2 SnSe 3 –Cu 3 SbSe 4 toward Higher Thermoelectric Performance

Enhanced thermoelectric performance of Bi2-xCuxS3 by hydrothermal synthesis and spark plasma sintering

Enhanced thermoelectric performance of BiCuSO by Pb doping and Se alloying

Nanostructured Bi2-Xcuxs3 Bulk Materials With Enhanced Thermoelectric Performance

Decreased order-disorder transition temperature and enhanced phonon scattering in Ag-alloyed Cu3SbSe3

Effect of Antimony Doping on Thermoelectric Properties of Zr0.5Ti0.5Sn Multi-Element Alloys

Thermoelectric Properties of S and Te-doped Cu2SnSe3 Prepared by Combustion Synthesis

Enhanced thermoelectric properties of Cu3SbSe4 via configurational entropy tuning

Enhanced Thermoelectric Performance of Β-Zn4sb3 Based Composites Incorporated with Large Proportion of Nanophase Cu3SbSe4

Microstructure and thermophysical properties of Mg-2Zn-xCu alloys