ISIJ International, Vol. 46 (2006), No. 4, pp. 539–545
Yin HEBI,Yao MAN,Fang DACHENG
2006-01-01
Abstract:It has been reported that the primary cause of defects in the cast strand is the inhomogeneous heat transfer from the strand to mould during the continuous casting, causing the irregularities in shell thickness, since differences in thermal shrinkages of the thicker and thinner regions result in stress gradients which may be relieved subsequently by surface cracking. Thus, the task of this work was to develop an appropriate mathematical model to further increase the understanding of the mould heat transfer and strand solidification behaviors in the real casting process. In the earlier stage, one-dimensional finite-difference methods were developed to calculate the temperature field and the solidification of the continuously cast steel shell. And many two-dimensional thermal mathematical models, either in transverse sections or in axial planes, had been developed to predict the shell thickness. Since then, some models were also developed for the coupled analysis of them in continuous casting process of both billets and slabs. Some models even considered more details the treatment of the heat transfer through the mould flux layer, such as the radiation and conduction, the temperature dependent properties, and even the film thickness related thermal resistance between the mould/slag film/the solidifying shell. However the models still can’t simulate the complex phenomena due to the temperature dependent physical properties and the contact state between the solidified shell and the mould. To make the results better reflect the real continuous casting mould process, typically, thermocouples or pairs of them are used to determine the temperature distribution along the centerline for slab and billet casting as the boundary condition, linking the numerical simulation to the measurements in plant trials. However, it was not considered that the mould heat transfer around the perimeter is non-uniform in the plant production. One document, considering the non-uniform heat transfer around the perimeter was previously reported by MAN, but neglecting the longitudinal heat conduction, which is considerable in the vicinity of meniscus. To have better knowledge about the real continuous casting mould process in plant, which is still not fully understood, it is very importance to be able to calculate the real things associated with the thermal behaviors in the mould, i.e. to have a formal apparatus for an inline and offline quantitative an analysis, so integrating the numerical simulation with the measurements in plant trials is the key problem. In the present work, an attempt is made to improve this situation by developing an appropriate 3-D inverse problem model from the measured temperatures by the thermocouples buried in various transverse and longitudinal sections, considering the heat transfer both around the mould perimeter non-uniformly and down the mould length and, in so doing, a fresh insight has been gained into thermal states of and in mould by identifying the thermal resistance between the billet and mould. ISIJ International, Vol. 46 (2006), No. 4, pp. 539–545