Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Melting and Flowing Behavior of Mold Flux in a Continuous Casting Billet Mold for Ultra-High Speed

Transient flow and mold flux behavior during ultra-high speed continuous casting of billet

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

Thickness Distributions of Mold Flux Film and Air Gap in Billet Ultra-High Speed Continuous Casting Mold Through Multiphysics Modeling

Numerical Simulation of the Fluid Flow, Heat Transfer, and Solidification in Ultrahigh Speed Continuous Casting Billet Mold

The Effect of Mold Structure and Cooling Parameters on Heat Transfer during Billet High-Speed Continuous Casting

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Effect of mold electromagnetic stirring on metallurgical behavior in ultrahigh speed continuous casting billet mold

Hydraulic Modeling on Flow Behavior in High-Speed Billet Continuous Casting Mold Considering Hydrostatic Pressure and Solidified Shell

Optimization of Billet Tube Mold Designs for High-Speed Continuous Casting

Optimization of submerged entry nozzle parameters for ultra-high casting speed continuous casting mold of billet

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Heat transfer behavior in ultrahigh-speed continuous casting mold

Investigation on Heat Transfer in Molds with Different Water-Cooling Structures Under Billet High-Speed Continuous Casting

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

In-depth study of mold heat transfer for the high speed continuous casting process

Analysis of Thermo-fluidic and Phase Change Behaviour of Liquid Steel in a Continuous Billet Caster Mould: Effect of Casting Speed

Numerical Simulation of Flow, Heat, Solidification, Solute Transfer and Electromagnetic Field for Vertical Mold and Curved Mold of Billet

Numerical Study on Characteristic Positions and Transition of Flow Patterns in a Slab Continuous Casting Mold

Development of Mold Flux for Continuous Casting of High-Carbon Steel Bloom