Abstract:Nanoscale [(Ba0.85Ca0.15)(0.995)Nd-0.005](Ti0.9Hf0.1)O-3 (Nd-BCTH) ceramics were prepared via the hydrothermal method, and the effects of sintering temperature and holding time on the phase structure, micro-morphology, electrical and optical properties of the Nd-BCTH ceramics were explored. All the Nd-BCTH ceramics present rather pure perovskite structure with composition approaching rhombohedral phase around the morphotropic phase boundary (MPB) region. The highest relative density is obtained for the sample sintered at 1220 ? for 10 h. The existence of Ba2+, Ca2+, Ti4+, Hf(4+ )and Nd3+ is confirmed and the elements distribute rather uniformly detected by X-ray photoelectron spectrometer (XPS) and energy dispersive X-ray (EDX) analysis. The ceramics present nanoscale grain size, which tends to increase with the increase of sintering temperature and holding time, and significantly affects dielectric constant and Curie temperature. Very thin and narrow ferroelectric hysteresis loops are observed, where a considerable energy storage density (173.88 mJ/cm(3)) and high energy storage efficiency (80.68%) are obtained at low electric field. The increase of sintering temperature and holding time induces a red shift at 400 nm absorption edge and a blue shift at 300 nm absorption edge in the Nd-BCTH ceramics, and all ceramics have a maximum absorption value at around 260 nm. Under the excitation of 269 nm light, the Nd-BCTH ceramics show the strongest fluorescence peak at 473 nm, corresponding to the (4)G(3/2)-> I-4(9/2) transition, emitting indigo blue fluorescence. When the ambient temperature is above 400 ?, grains conduction dominates the conductive mechanism in the nano-sized Nd-BCTH ceramics. Such conduction can be attributed to oxygen vacancies caused due to the evaporation of alkaline-earth metals during high temperature sintering, and show typically thermally excited relaxation process. (C) 2022 Published by Elsevier B.V.

Properties of Ultrafine High Curie Temperature (1-X)bisco3-xpbtio3 Ferroelectric Ceramics

Bulk Dense Fine-Grain (1−x)bisco3–xpbtio3 Ceramics with High Piezoelectric Coefficient

Synthesis of Nanosized (1 − X )bisco 3 − X PbTiO 3 Ferroelectric Ceramic Powders

Effects of Nano-Sized In2O3on Sintering Behavior and Electrical Properties of 0.28Pb(in1/2nb1/2)o3-0.40Pb(mg1/3< /Sub>nb2/3)o3-0.32Pbtio3ceramics

Dielectric and Piezoelectric Properties of BiScO3-PbTiO3 Piezoelectric Ceramics with High Curie Temperature

Ferroelectric and Magnetic Properties in (1-X)bifeo3-x(0.5catio(3)-0.5smfeo(3)) Ceramics

Facile Preparation and Performance of Novel High-Tc Xbi(ni1/2ti1/2)o3-(1-x)pb(zr1/2ti1/2)o3 Piezoceramics

Preparation of Nanoscale [(ba0.85ca0.15)0.995nd0.005](ti0.9hf0.1)o3 Ceramics Via Hydrothermal Method and Effect of Grain Size on Multifunctional Performance

Structural Evolution, Electrical Properties and Electric-Field-induced Changes of (0.8− X )pbtio 3 – X BiFeO 3 –0.2bazro 3 System Near the Morphotropic Phase Boundary

Preparation and Characterization on Piezo-/Ferro-electric Properties Of(1-X)(knn+lt)+xbi Ceramics

Preparation and Properties of Fine‐Grain (1−x)bisco3−xpbtio3 Ceramics by Two‐Step Sintering

Phase diagram and properties of high TC/TR-T Pb (In 1/2 Nb1/2) O3- Pb(Zn1/3 Nb 2/3) O3-PbTiO3 ferroelectric ceramics

Phase evolution and thermal stability of high Curie temperature BiScO$_3$-PbTiO$_3$-Pb(Cd${1/3}$Nb$_{2/3}$)O$_3$ ceramics near MPB

Phase formation and performance of high Curie temperature Bi(Ni0.5Ti0.5)O3–BiFeO3–PbTiO3 ceramics

Effect of Different Sintering Temperatures on the Electrical Properties of SBTi Ferroelectric Ceramics

Piezoelectric Properties and Thermal Stability of Pb(Yb1/2Nb1/2)O3-BiScO3-PbTiO3 Ternary Ceramics

Preparation and Characterization of (1-X)bisco<sub>3</sub>-xpbtio<sub>3</sub> Ceramics by Two-Step Sintering

Phase transition and electrical properties of Ba 0.7 Ca 0.3 TiO 3- BiFeO 3 ceramics

Properties of CaxSr1-xBi4Ti4O15 Ferroelectric Ceramics Prepared by Sol-Gel Method

Simultaneously Enhanced Ferroelectric and Magnetic Properties in 0.675bife1−x Cr X O3–0.325PbTiO3 (x = 0–0.05) Ceramics

Effect of Gel-Calcination on Piezoelectric Property in (1-X)bisco3-xpbtio3 Ferroelectrics