Abstract:With the development of analytical instrumentation to minimization,integration and automation,the microfluidic chips,which are more integrated,complex and diversified,have been applied widely on the manufacturing of analytical instrumentation.However,the present photolithography-based microfabrication technology,which is only able to pattern microchannels with simple inside structures,can not follow the rapid development of requirements.For solving the problem,a fabrication method based on the restricting effect of laminar flow is proposed for the micro etching on isotropic substrates.Experiments were conducted inside glass-based microchannels,in which certain etchant was used to form complicated microstructures.The flow parameters’ effects on the aspect ratio,side wall profile and etching rate were revealed by the experiments.The experimental results reveal that the topography of micro structures patterned with the restricted flow etching method is mainly determined by the flowrates of separator and etchant.The computational fluid dynamics（CFD） model on the interface between multiple streams was established for the etching process,and analysis on the causes of various micro topographies was conducted based on the CFD simulation results.The experimental data consisted with the simulation results very well.The investigation depicted in this paper indicate that the flow restricted etching method provides sufficient references for the research and understanding on the mass transport at the liquid-liquid surface in the microchannel and can be used to pattern complex micro structures with high aspect ratios,meantime,it greatly enriches the microfabrication technology for microfluidic chips.

Versatile control of multiphase laminar flow for in-channel microfabrication.

Electrostatic layer-by-layer nano-assembly: films, cantilevers, micropatterns, and nanocapsules

Inertial Particle Focusing and Spacing Control in Microfluidic Devices

Controllable Preparation of Microscale Tubes with Multiphase Co-Laminar Flow in a Double Co-Axial Microdevice

Micro Etching Method Inside Microchannels

Study On Characteristics Of Interface Between Multiple Laminar Streams And Application For Secondary Etching Inside Microchannels

The Performance and Fabrication of 3D Variable Cross-Section Channel for Passive Microfluidic Control

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

An Enhanced One-Layer Passive Microfluidic Mixer with an Optimized Lateral Structure with the Dean Effect

Control of two-phase flow in microfluidics using out-of-phase electroconvective streaming

Immiscible Two-Phase Parallel Microflow and Its Applications in Fabricating Micro- and Nanomaterials

Fabrication of Size-Controllable Nanofluidic Channels Using Angled Physical Vapor Deposition

Integrated fabrication of micro/nano-fluidic chip based on nano-imprint lithography and bonding

A novel abrasive water jet machining technique for rapid fabrication of three-dimensional microfluidic components

Fabrication of microchannels by space-selective control of phase separation in glass.

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Morphology Control of Microchannel Cross-Section Using Sacrificial Spinning Fiber

A simple method for fabricating multi-layer PDMS structures for 3D microfluidic chips

Fabrication of polydimethylsiloxane nanofluidic chips under AFM tip-based nanomilling process

Iterative Learning Control of Two-Phase Laminar Flow Interface in Y-Shaped Microfluidic Channel

Direct, one-step molding of 3D-printed structures for convenient fabrication of truly 3D PDMS microfluidic chips