Abstract:Surface heat flux is an important parameter in various industrial applications. This paper compared several algorithms for estimating surface heat flux using both simulated heat flux and measured temperature in response to ultra-fast surface cooling. Two different strategies were employed to measure the surface temperature, using the thin film thermocouple with a 2 mu m depth deposited directly on the cooling substrate surface (direct surface temperature measurement) and the fine thermocouple with a 100 mu m bead diameter placed on the surface of the cooling substrate and covered with aluminum foil (indirect surface temperature measurement). The algorithms of Duhamel's theorem, sequential function specification method (SFSM) and transfer function method are briefly analyzed. A new method is proposed that the surface temperature is first calculated based on Duhamel's theorem and then the surface heat flux can be estimated, in order to improve the accuracy of results in the case of the indirect surface temperature measurement method. The transfer function is obtained by solving an auxiliary problem and thus the transfer function method can be implemented to solve multilayer, semi-infinite inverse heat conduction problems. Accuracy and sensitivity to noise are examined using both the simulated triangular pulse heat flux and the measured temperature data. Duhamel's theorem is insensitive to noise, but is unsuitable for predicting surface-heat flux in the indirect measurement method of surface temperature. The SFS method can provide acceptable results of surface heat flux using both measurement methods. However, a noticeable discrepancy exists as the heat flux changes extremely quickly and it suffers considerably from noise. The transfer function and newly proposed methods are both effective in inhibiting noise, and produce very similar results, which match the simulated heat flux exactly and have a negligible standard deviation and residual temperature. (C) 2016 Elsevier Ltd. All rights reserved.

Methods comparison in computation of temperature rise on frictional interfaces

Heat Analysis of Sliding Abrasive Particle Micro Contact Process by Finite Element Method

Comparison and improvement of different calculation schemes on surface turbulent fluxes

On the Temperature Rise of Bodies Subjected to Unidirectional or Oscillating Frictional Heating and Surface Convective Cooling

A Comparative Study of the Methods for Calculation of Surface Elastic Deformation

Calculation of Temperature Fields of Bodies in Sliding Contact Without Lubrication

Estimation of Real Contact Area During Sliding Friction from Interface Temperature

Calculation of Temperature Field in Dry Sliding Contact at Different Speeds

A Three-Dimensional Fictitious Domain Method for Direct Numerical Simulations of Particle-Laden Flows with Heat Transfer

Atomistic insight into flash temperature during friction

Experimental and Finite Element Analysis of Frictional Heat Distribution during Sliding Friction

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems

Numerical Scheme Solving the Temperature of the Interface Between Gas and Heterogeneous Solid with Phase Change

A quantitative method of calculating transient nonlinear heat partition coefficient between clutch friction discs with deep learning

A thermal model in frictional contacts

Numerical Analysis of Rolling-Sliding Contact with Frictional Heating

Improvement of the Coarse-Grained Discrete Element Method for Frictional Particles

Derivation of Coefficient of Friction at High Sliding Speeds from Energy Conservation over the Frictional Interface

Algorithms for the Estimation of Transient Surface Heat Flux During Ultra-Fast Surface Cooling

Temperature Rise in Frictional Sliding Contact of Elastic–Plastic Solids with Fractal Surface

Dynamic In Situ Measurements of Frictional Heating on an Isolated Surface Protrusion